Recent content by JayTech

Ok, if you already grounded it, easiest way would just be to splice into the power wire for the low beams. Should be Pin number one for either the base LED lights or the Higher trim LEDs going by the wiring diagram I am looking at. This is the headlamp connector itself. Pin number one shows it...

You would need to look at a wiring diagram going to one of the headlamp assemblies and see which wire provides power to the low beam. Then you would need wire strippers or a wire tap that pinches the wire and splice in the wire for the lights to the headlamp wire. You would also need to do the...

I will say, if neither of these allow the lights to come on only when the headlights are on, then the only option would likely be to tap into the power wire for the low beam itself. This will make it so they only turn on when the low beams come on.

You need to buy an Add a fuse/Micro tap and take the original fuse out of one of those spots, put the original fuse into the designated spot in the add a fuse, and a new fuse of lower amperage(preferably around 5-10A) in the second slot. This will keep the original circuit intact and piggy back...

Sorry I was going to edit my comment with a potential location. I am just looking at a generic wiring diagram and it says Fuse 1 and Fuse 3 are for headlamps. They are 30A fuses and in the engine compartment. But I don't know if this is trim specific and if LED projector vs Reflector changes...

You could probably use an Add a Fuse kit to piggy back off the headlamp circuit. There should be a fuse somewhere either in the engine compartment or interior BCM fuse box. This allows you to piggy back off them and make a new circuit for the raptor lights.

It should fit without issue. The Lariat has the same grille as the XLT

As a detailer and PPF installer, I would recommend PPF at the very least and either a top coat, or full ceramic coating on top of the PPF. While ceramic coatings will help protect the paint, they are still susceptible to paint chips. A PPF wrap will keep the paint safe from any damage and...

Damn, I was looking at buying a Ranger within the next month or so but it says this might come to Canada, so I might just wait or if I do buy the Ranger, trade it in for one of these if they do come lol. This would be so cool to have.

Looks great! Been thinking about doing this to mine when I get it. How is the fitment? Are there any gaps or spots that don't quite mount back in correctly or does it fit almost as good as OEM? I am OCD about this kinda stuff so if it has a gap I will always notice it lol

When there are F150s, 250s, 350s and larger, I would still consider this a small truck. In technical terms yea its a midsize truck and the Maverick is a compact truck but its still "small" in comparison to a full size truck.

Hearing you cancel your order on a Tacoma and going to the Ranger is very helpful as I am currently on the market for a small truck and have been on the fence about getting either the Ranger Lariat or the Tacoma Limited. I personally loved the way the Tacoma drove and the seats were super...