Search results

This has happened 4 times and my only solution is to not lock the truck - not good. Can someone tell me where the sensor is that tells the truck when the hood is closed? It's been wicked cold here lately which may contribute to the fault. Thanks

Just received this today to replace the previous version which I wasn't satisfied with. SDF 3D stepped up and sent me the updated version - huge improvement. My pictures show the color wrong - it is mat black. Awesome company to work with ---

I like them - every other aftermarket version I see looks like what is stuck to that rusty pickup seen in the parking lot at Walmart's.

The compressor and all tools required to manage tire pressures fits in a saddlebag liner. The valve caps were long pointed types that I cut to just poke out enough to grab. The Lock N flate air chuck reaches in and clamps hard on the valve - no leaks. I can just leave the fitting open to...

There's that big rubber block behind the mirror - I'd like to tap into something there to power a mounted camera. Thanks!

Out pre-running SnoDrift rally stages today. 2024 RR, Procal tune, stock K03's - 28psi front/28 rear, Baja mode. I slowed down to gap the trucks ahead of me - then full trhottle.

I received my NAPA MT-WM102-15C today and it's what I expected - going to start on the mods soon. I've read about the silly bag they send it in and that was confirmed when the box was opened. I started looking around my house/garage for something to fit this and found a set of saddlebag liners...

It's winter - deep snow - I want to remove the running boards and would like to have the tools ready before I crawl under. Thanks!

Dealer installed this morning - service guy mentioned the screen flickering right off. Service writer asked me if I had purchased it from them and I told him I saved $210 by ordering it online. I told him what I just spent on the truck - plus the fact they made $5000 on my trade-in - I was...

Added these valve extensions yesterday - took wife and best pals to a New Years party last night - leave party to find flat tire. This is what I discovered --- No excuse for that lack of QC . . .

Late 80's - purchased this Ranger new - 4x4/V6/5 speed - loaded up to go camping for a week with pals in Tennessee. Two weeks ago, took delivery of the next green Ranger in my life. Looking forward to new adventures with this one ----

This question is about "can it be done without affecting the warrantee" not "should I do this". The drop would be 2" front, 3" rear. Thanks!

It left the factory lot (7 hours south of its new home) a week ago - just in time for some wintertime fun. Had a foot of lake effect overnight - maybe another foot today. Going to be fun getting to know each other.