Search results

I was at Leer East last June looking at the covers on display. The manager already knew that Ford was making a change to the bed in 2026, but he did not know the details.

2001 TransAm WS6 with 23k miles. I am the original owner.

KB3B-16N452-A was not available from Ford when I did a search. I damaged mine and had to order 2019-2023 Ranger Running Board End Cap KB3Z16A454A. The number stamped on the part is KB3B-16N452-A, but depending on the revision of the cap, you will need to modify or remove the center tab that...

I had Sportwing body side moldings on two cars. Paint match was good and still looked new after a few years.

Look the truck over carefully before signing any papers.

I am considering these when available because I already have Weathertech sill protectors installed. Ranger 2024-2025 Rocker Panel Protection - Body Armor by Husky Liners® | Accessories | Ford.com

My last bug shield chipped the paint off the front edge when closing the hood. I'm considering the Airplex, but will probably put some PPF on the front edge of the hood where the shield contacts it.

Here is another one from down under that can ship internationally. Airplex NZ

Very interested also. I prefer a non-taped on deflector.

I had two different quotes for spray ins at $650 and $750. One had an upcharge of $50 for Rangers and could not explain why. Probably tie down bolt replacements. I have had Penda/Duraliners in six trucks with no problems, but all had caps or tonneau covers on. I would have preferred one piece...

I installed the Weathertech on my Lariat and really impressed with the quality and fit. Wider and longer than the Ford molded splash guards. Fronts also hide the short piece of box steel that is attached to the frame.

I had the same loss of power everyone is mentioning when turning right from a stop in the 2021 ranger that I just traded. Only lasted a few seconds and it was not frequent, maybe about a dozen times in three years, so I never informed the dealer at service. My 2025 with the 2.7 has not done it...

I had one bolt strip out because I did not have a T40+ bit and could not find one locally. I replaced all the bolts with these found on E-bay. Replacing all with Fords earlier T40 versions would cost twice as much.