Search results

Thanks for the input guys, I’ve ran only Shell 91 since new. I think I’ll just continue to run the same after the tune since it’s my daily. I used to run 93/94 in my F90 M5 with 10% of 100% ethanol in it, dyno results showed more power with the E10. However that wasn’t a daily and drove around...

Called my local Ford dealer for the ProCal tune and they advised to "drive on 2 full tanks of Shell V-Power 93 octane or Chevron 94 octane before doing the tune" and they recommended this tune should be used with 93 octane or above. The RR is my daily so I wasn't planning on using 93+ so I may...

Looks so good! I ordered the same tire but I’m running Method 703 17x8.5 +35mm. Are you still running stock UCA? How’s your alignment? I think according to nedmo an aftermarket UCA is required to get the best alignment when running 35s with 2”/1” lift so I’m considering the UCA but I’d rather...

If running 35x11.5R17 on a 17x8.5 +35mm offset wheel, is it possible to get a good alignment running your 1.5” front / 1” rear lift kit with factory UCA or do I need the 32mm strut spacer 2” lift kit up front to fully offset the radius increase of the 35” tires? Wasn’t planning on buying UCA but...

I have a 2025 4 Runner TRD ORPH on order with a Feb ETA, hope you don’t miss the RR! As for my RR I don’t mind a little tucked, less chance of gravel/rock spray and tire hitting the fenders from full bottom out. I may do the collars like you did to help prevent some of that bottoming out the...

Your truck looks amazing! I think in an earlier post you said you were originally going with +35 offset, what made you go to +25? I have Method 703 17x8.5 +35 just waiting for the same tires to show up so I wonder since I have +10mm more offset if I will still need to remove the crash bars. I...

Will the bulkhead MOLLE panel work if I am running the modular bed liner (Ford part #: R1WZ2600038A)? From what I can tell it may mount to where the front bed tie downs are which in my case is recessed behind the bed liner and not sitting flush. Would love to mount my MAXTRAX boards up front...

Any 2025 RR here get the CEL from the S&B intake? Their website says the revision for 2025 model is still being worked on so I’m wondering if I should hold off on my order til it’s sorted. I’m also running the UPR dual valve catch can so I’ll have to drill into the piping that connects to the...

Likely poor grade hardware. No way a M8 bolt would sheer off this easily. I wasn’t putting a ton of force on it either. Anytime I felt resistance or creaking I would turn it clockwise to help break up the loctite. The other 11 were a breeze, the 12th and last one was unlucky. I had success...

That looks so good! I may get the same tires but I’m running them on Method 703 17x8.5 +35mm offset so it’s really good to know that you aren’t rubbing at +25 because I’ll have a bit more clearance. Also considering AT4W in 35x11.5R17 since I loved those on my other truck. Hopefully this size...

Just picked up my Ranger Raptor 3 days ago, your write up helped me a lot. There are 12 bed tiedown bolts. I was literally on the last one and the bolt head sheered off about 1/3 of the way out on the passenger side rear. Tried my bolt extractor kit to no avail, it’s in there very tight due to...