Search results

Yes, it’s a great fit. Probably best to sound deaden that area as much as possible to reduce rattles.

That looks very nice and clean.

Ok, what I have done is less elegant for trying to get it through the boot. Just more time than I am willing to spend personally. So all I do for tapping the wires is remove some of the tessa tape to expose more of the wire. Then I use wire stripper to peel back a section without cutting the...

I just want to make sure I'm on same page. You are just trying to tap for a signal for an amp? I know for sure because I just tapped it today. Left front door speaker is Blue + and Gray -. I just spliced into the blue with my positive speaker wire and gray negative wire. Then ran it from...

No worries. I just tapped one side as I am only using the sub for now so I just used a jumper on the LoC22 to jump from the right side to the left inputs so the signal for remote turn on worked. If you are going to power multiple speakers from an amp I would definitely tap both sides. I do...

You could definitely tap the rear speakers to whatever you are using to process into a signal for the amp. I just always go to the front speakers by default as they usually have a full signal. I used JL LoC22 to get my signal converted for hooking up to amp. Some amps have this built in so...

Everything but the subwoofer I am running off factory. It is good enough sounding for me after upgrading the speakers.

I just reused everything a lot from my Maverick audio build that I took out when I traded in my Maverick ( needed a little more towing ). This consists of JL LoC 22 to get signal for the mono amp. I tapped front speaker for the signal to the JL LoC 22. Down4sound JP8 mono amp 800w DSP (...

I actually like it a lot. Probably good for a sub that will fit the dimensions of the enclosure. Sealed box of .35 to .6 volume. I have deadened the tub but I think I need to do the outside of the enclosure too but not sure. There is a rattle somewhere in the back on deep bass I need to find...

I did something crazy because I had a hard time finding a prefab sub box for under the seat besides the JL $1K option. I already had a 10" subwoofer just need the sub box. I ordered this all the way from Australia. Total cost was $180 which honestly $60 being shipping is not a bad deal. It...