Search results

I didn't see any fasteners to remove it, but I wasn't paying close attention. That said,, it looks like American Adventure Labs cut their bracket off.

Thanks all your advice. I got the plug out after another attempt. The trick is to slide the grey clip on top back (towards the front of the vehicle in this case), then press down on a tab on top while simultaneously pulling the plug out. It’s very finicky, but the plug comes fairly easily once...

Does anyone know how to uplug the 7 pin connector from the hitch? I want to install a Leer wiring kit for the CHMSL (part #300200), which requires plugging into this location. The grey tab at the top slides back a little buy doesn’t seem to release the plug - it doesn’t budge at all with firm...

Unrelated note - I see you installed positive pressure air vents on your GFC topper doors. Are you happy with them and if so, where did you get them from? I am looking to do the same, but have yet to find one I like.

Any chance you could share pictures, including where you bolted it underneath?

Based on your description, the tires aren’t the primary issue. I’d hazard a guess you are coming from a sports car, which tend to be far more forgiving of less-than-smooth driving and of course have tires that are an order of magnitude better on the street. Dial it back a bit and focus on...

I think what you're looking for is Connector 5 ("CHMSL Circuit") on the lower left corner of page 11 of the Body Builders Layout Guide: This looks to be similar to the previous gen Ranger. There's a photo in this thread...

The list price for those bed rails is about $180 each, so caution is indeed warranted. If I do try it, I will wait until a hot summer day, to minimize the chance of the plastic breaking instead of deforming. I wonder if instead of removing them, maybe it would be possible to safely pry the...

@CrustyNoodle Did you need to remove the tail lights to access the clips? Also. were there any issues re-using the bed caps, e.g. damaged clips that would no longer hold after the rails were removed. or any other issues affecting fit of the rails?

Agreed, this is the best-looking canopy out yet; given manufacturing lead times, transit time, etc., no doubt this is probably a bare minimum of 6 months out. One minor issue that perhaps they can address before releasing it in North America: the shelf/cubby area behind the right window is...

Confusingly, Ford Parts lists a 433 MHZ sensor for a 2024 Ranger Raptor (Part #: ML3Z1A189B) - it even labels it as "Tire Inflation Monitor. Tire Pressure Sensors 433 MHZ. ". Obviously everyone's experience above confirms they're actually 315 MHZ, and indeed, the manual specifies them as " 315...

Any info on pricing?

Thank you. For anyone else trying to figure this out: You need to go into "Configure MyView" and add this screen. From the manual: Customizing the Instrument Cluster Display - Vehicles With: 12 Inch Screen Adding Screens Using MyView Using the instrument cluster display controls on the...

I am embarrassed to ask this this, but after reading the manual and a solid 15 minutes of poking around the various menus I cannot for the life of me figure out where to view tire pressures, and to reset the tire pressures (if that's a thing on Fords - the manual doesn't mention it). The full...