Recent content by clarke

@CaptAngry if you have a 3d printer, I made custom mounts for the rear speakers and I modified some I found online for the front doors. I can send you the files. The rear door mounts angle them correctly as well.

Did y'all get your aluminum from the same supplier that Ford uses, which burnt down?

Ha ha. As much as I'd love to drive out there, it's a bit far from East TN. I'm more than happy to message you with measurements I would need and some ideas to incorporate into your future design.

@AdventureLab Are there plans for full height cross bars in the works? I am looking to sell my wagon after I do some work on it, but can't until I can carry my canoe with my raptor.

Oh Snap! I know what I'm doing tonight. Thanks so much!

Can't wait to print a set of these for my Raptor. I've got a bunch of PC-CF and PC-ABS, so I might try that out.

@AdventureLab would it be possible to get a slice from your 3d model just of this face? I can't find my little protractor, so it will be a decent amount of trial and error to get the hole spacing correct in Fusion360. I ordered some carbon fiber poles that I want to mount on the rack to serve...

I'd put some sound deadening mat on the rear wall and pull the carpet to put it on the floors.

Well this handle is working a lot better than I expected. Probably one more revision and I'll have it where I want it. I can shake the whole truck with it.

Need an honest opinion. I modeled this up last night and did a draft print, before I realized I could get by just as easily with having a loop of climbing webbing attached to the cross bar to pull my fat self up into the bed. 😅. Should I keep trying to model up a handle to print and attach to...

I think I'm going to have to design and 3d print a tool to hold it for at least getting the nut started. 😆

For me, the side panels are the only ones that came with rivnuts. I bought the rear panel separately and it didn't have any. It came with two nylock nuts.

Does anyone have any suggestions for installing the nuts for the top 2 screws on the back molle panel? Even with my small hands I can reach to get the nut started.

Thanks so much! I just submitted a ticket with my order number.

Thanks so much! I'll email support with my order number.