Recent content by Goldylox22

Of course! I’d been aware of swarfworks for some time and when I went to get a third brake light these were brought to my attention by my Raptor run group. High praise from them and the fact the two bed lights point down into the bed instead of needing a third Baja designs s2 sold me. Spent 4...

So I had it installed, didn’t do it myself cause I also had radio mounted in the center console and they had to run the antenna cable through to it. I do know they did have to drop the headliner for that specifically. Wish I could be more help

Can’t help ya there u ordered through my Raptor group so I don’t have an exact timeline

Following up on this, I’ve been running it all day for four days now out in Utah in a group that frequently uses the radio and where it’s hot and it hasn’t even come close to being a temperature that I’d be concerned about

Doesn’t look like they are

They’re on AUX5

It’s a $60k truck, I’ll pay $1k to not get rear ended on the trail

They provide the typical wiring you’d get from ordering them from Baja Designs. Their wiring for the brake lights is plug and play into factory. I actually don’t know if they are on as running lights but I can check later and let you know.

That’s the one

The temporary attachment but permanent wiring I can’t get behind. I’d prefer fully integrated or not at all but that’s just personal preference. As for the antenna my third brake light has a cap for when I don’t use the antenna, when I put it on I’m in situations where there’s no parking...

White light does illuminate the bed? The amber are dust lights for off-roading

Thanks for the note, I’ll keep an eye on that

Yes, the three circular lights that aren’t illuminated are red brake lights

The seal they provide as part of the light looks pretty robust. It’s difficult to see in the photo since it’s pressed up against the cab pretty hard but tbh only time will tell on the effectiveness.