Recent content by lifeline

I don't

Just installed these today on stock non beadlocks and feel no difference in compliance between these and the KO3. I can’t comment on performance yet.

I just installed this exhaust on a truck with spd downpipes. Install was simple primarily because the quality of materials and fit/finish were excellent as was the very detailed instruction pdf. The only install gripe I have is where the instruction call for relocating the harness that is...

very strange. Mine initiated the process within seconds of inserting the stick. Good luck figuring this out, sorry I couldn't help.

When updating sync via FDRS, you go through the module update just ike you would with any other module update but it will at some point prompt you to insert a usb stick into your pc and if it likes the type of USB ( I use an old cheap one but made sure it was the minimum memory size, the first...

I installed in the Ranger of different customer of yours, and his didn’t have have a hole so I made one. Also didn’t like how the crossover pipe fit in the drivers side turbo boot, something is off about it.

Don't forget to drill a drain hole in that airbox.

ahhhh, that makes sense. I threw mine in the trash with the grill shutter assembly

The bracket that shipped with the intercooler must be for some other application, it isn't used. The plastic frame with non powered shutters on the back of the cooler in the pics is transferred from the old cooler to the new one.

@Caneman88's third image shows what I was talking about regarding the 4th corner of the rear shroud not lining up with the tab on the intercooler.

No. There are two bolts holding the shutter system in place from above. I think they were 8mm but I don’t recall. Your best bet is to use a short ratcheting wrench as there is very limited space to get anything else up there.

I installed a CVF intercooler. I tried leaving the grill shutter system in place but I found it to be impossible as the top of the intercooler interferes with the top of the shutter system frame not allowing it to be pushed up into place. The shutters themselves are very close to the new...

Got it. So it’s probably as the poster above mentioned and Cobb won’t mess with it after their skirmish with the EPA.

Can you disable ASS with HPT? I went with Cobb only because I was familiar with it from Subaru, I know nothing about HPT.