Search results

I am not in the auto industry and don't know much about dealers or what their practices are. But I do always find it funny at the lines about modifications not impacting resell value / trade in value much at all. The last 2 vehicles I have traded in had a lot of mods (bumpers, skids, rock...

I'm not sure what setting needs to be done. Just adding that mine does not do this, so there is a way. When I turn on the truck, it connects to my phone via apple carplay and music starts from that. When it is unable to connect to my phone, it just stays on the bluetooth connection screen, does...

Mind answering which tune? My ford procal tune just arrived yesterday, planning to have it installed on Monday. Based on reviews I've seen, I didn't think that one changes auto start stop behavior.

What bed mat is this? I was considering ordering the ford mat with my rewards points, but I like how this one has the "walls" on the sides This is a sick setup btw

Adding these separately in case it helps with the flange lining up. So I didn't take any photos from before installing it, this is after I bent it up a bit to make it reach. When I first installed, I could not get the bolt on the passenger side into the bulkhead, the angle it was bent at just...

The Bakflip Mx4 compatibility photos are attached. No accessories yet, so super basic, but that's probably best to show fitment. This is the latest gen Bakflip mx4 (bolts to side of bed instead of clamps). Fit's perfectly. Do need to remove the cover when installing the bulkhead molle, but the...

There are 6 holes in total, the kit just uses the middle 2 however. It's very sturdy with just those 2 installed.

I swore I wouldn't get PPF again after it discolored / dirt got under the edge on my last Tacoma within 3years. I didn't use Xpel though, and might do that this time around. I got a quote for less coverage than you listed (no fender, no a-pillar, no roof coverage). The quote was for $875 usd...

If it's the same as the one I received, you can't get the bolt into the top of the bulkhead with how it is bent. There is a gap that makes it slightly out of line. I just braced it in a vice, wrapped in some shop towels to try and not scuff it up. Then used a large crescent wrench to bend it...

Yeah, that interior looks so clean. Now I have to try and figure out how to get rid of all my orange

@AdventureLab I just finished installation of my Molle Kit (bulkhead, driver side with power cutout, full passenger). A few takeaways for you First, you can add that this is compatible with the Bakflip MX4 to your Verified to fit section. If you like, I can attach photos of it tomorrow when...

Oops, you're right. I have the yankum, not the bubba. I got them confused. Project Farm also has a video on these!

They are awesome. Watch some Matt's Offroad Recovery videos to see them in use. Unless I'm going somewhere I expect to use it, I leave it in the garage though. It takes up a HUGE amount of space. The ARB kenetic strap isn't quite "as good", but it takes up 25% of the room in the truck, so I...

10 quarts (2 jugs) of Kirkland full synthetic 5-30 cost me $36 That’s almost half the price per change, and I change it about 3 times a year. I’m also changing it on 3 other vehicles 2ish times a year. It’s not a lot, but it adds up to a couple hundred bucks each year. When all the tests I’ve...

When I use mine I'm pretty sure it's more of a "BEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEP"

This thread had me curious, I would be really peeved if the lean was noticeable. I would think an inch would stand out, but had not noticed or checked mine. With a full tank of gas my driver side is only 1/8th inch or about 2mm lower. Build date Nov 2025. Maybe this was fixed with the newer...

They came to the same conclusion. Project farm is just entertaining, oil geek is not imo. Super tech, Amazon basics, Kirkland are all made by the same company. It’s a fraction of the cost and very good performance. Very slightly worse than amsoil / pennzoil. To some that tiny improvement is...

Nah. I noticed it a couple of days after picking it up. Never pursued anything about it. Was thinking I’d see if I could adjust it, but hadn’t looked into how. Sounds like I wouldn’t be able to fix it anyway though :/

I have this on the passenger side of mine, driver side looks good.

Project farm did a series with a ton of tests on motor oil. It was entertaining. The tldr is that there are premium motor oils that perform better (amsoil and pennzoil best of the best). But even the super tech and Kirkland oils are very good and available for much cheaper. I just use Kirkland...