Search results

Fits pretty flush. Tailgate edge looks bigger and it is because of seal but not much bigger. Also from behind looks like corners have bigger cap but this is due to raise tailgate edge in middle. A nice flush unit.

Installed the Bakflip cargo cover this weekend. Solid and lockable. Makes sure you read more than directions. Read all three. I think only three. They do not reference each other. There is the main one. One for the back rail. One for the shims you install before side rails. Only thing...

Took the Ranger in to get hitch installed as it finally arrived. My local dealer had an interesting Mustang on the outside display. A Ford Gulf Mustang. One of the better looking Mustangs. The carbon fiber pieces are well made. Learned it was my dealers own limited run of cars.

New addition for the garage. Not from a truck but it is from a Ford. An Edsel. I like it. https://etsy.me/2YFIpjX

Some have painted. Would need to be a flexible paint. One member used a silver paint stick to fill in Ford logo. Likely my route along with ecoboost letter filled in. Saber color would be nice, but likely silver.

Engine Cover. Foamy! Had the dealer order the engine cover and bolts. Took only 3 days. Guess they have more inventory than an OE hitch which is still not in. An odd cover. Made from dense foam. Don't hit it with anything. Feels like you could chunk it out. I guess the foam helps...

Good review.

Only two.

I could be wrong but will answer for him. If you have a clear shot down to the pinch weld then you might be able to install with steps in place. But it might be hard to slide them in place. Best would be to remove the step. Brackets could maybe stay in place. I am waiting for power steps so...

Bushwhacker Sill Guards Driver side done.

Bushwhacker Sill Guards Installed the passenger side today. Easy install and good fitment. Hardest part is getting the red tape cover strip started. Have to use tweezers!!!!!!!! Rear door should wrap under entire length of door like the front. But OK. Seals all the way around the piece...

Removed dealer front plate.

Added videos for Bed Link Ford option. Well made, good LED light and works well.

Nephews Ranger in lovely Washington State.

FX4 License Plate. Very nice Amazon. Packaged well. Foam around Plate was sealed. Then bubble wrapped and placed in a nice box. Ford FX4 Offroad License Plate on Black Steel https://www.amazon.com/dp/B001UFMWYQ/ref=cm_sw_r_cp_api_i_4n9mDbTRVNAPQ

Front License Plate Holder. Had plans to remove the front plate holder and just leave the front clean, but I found a great looking “FX4 Off Road” plate. Metal plus acrylic design. Might not hold up more than a year but looks good for now. This now clears the way to remove the rear quarter...

Very nice!

Cost? Years back I think I paid $5 per tire and could come back for refills no charge. Air loss. On average 1-2psi a month. In big temp swings 30 deg more loss. Temp swings show impact on air in tire. Inside of tire. Inner layer is butyl rubber. This layer retains air. Never 100%...

If they over inflate for seating, why does the plant not install an auto inflator that can inflate, deflate and then refill to spec? This would prevent shipping over inflated tires. And easy thing to develop for a plant. I know you said no once, I think, but thought the higher inflation...

Never said nitrogen did not pass through sidewalls. It does, just at a slower rate.