Search results

No, I am not sure about tongue weight, only total weight of truck and trailer.

Thanks I found it in previous post.

Sorry I guess it did not quote like I asked. In this pic the tailgate seat was that diy or was it a kit. I use the diamondback bed cover and love it but my main source of dust and water are from tailgate.

Did you make the tailgate seal or was that a kit you bought?

I haven’t yet and I’ve used it quite a bit. Though I did use computer fans I wish I would have and may still find some type of waterproof fans for when I spray out bed. But I usually just remove all the boxes anyway. So, probably won’t until they fail.

Looks great! Best onboard air compressor on the market in my opinion. I retro fit mine in a Milwaukee Packout box and mounted that on my bed slide. I used an Anderson plug where you put your switch. I just plug it in when needed and never have to open box as I ran all fitting to the exterior of box.

As far as power goes no problem at all. About once a month I pull a 12’ dump trailer with my 24’ Ranger Raptor. Last load for example I had truck and trailer fully loaded on the scale was 11,200lbs. Pulled it great, handled well, I do suggest that the trailer brakes are in good working order...

Extend the rear axle further back. Center the wheel well in the bed make it look more proportional. Make 35s for from factory at least on the RR.

Couldn’t find a photo of it loaded but here is an older pic of the side where I have the E-Track base mounted. It has some shovel mounts plugged in, in this pic.

Thanks it has been fun setting it up and customizing it the way I want it. As far as the load limit I’ve not run into a problem yet. I have had several hundred pounds on top of it in totes or Roam type cargo boxes with no problem. I bolted four E-Track tie down plates to the edge so I can strap...

I have the 270 on my RR and love it. Yes, you can fold back by releasing gas struts which is very simple and easy. For most long items lumber and such I just undo one end of strut and let the lid rest on material on top of tailgate. I was never a bed cover guy but this truck came with it and I...

Looks sharp! I have the 708 bead grips and am so impressed with them!

New here so I thought I would share my experience. When I picked up my 2024 RR previous owner had put the FMI 1.5" perch collar on the front, left rear factory. I drove it about a month until all my parts came in. I installed DV8 front winch bumper for a bronco and with a little welding and...