Sponsored

Search results

  1. ProCal not supported??

    You can have any ASE certified machinic do the installation. Doesn't have to be one at a dealership. I had my son-in-law do mine on my 2024 and Ford accepted his credentials.

  2. The ULTIMATE guide to lifting your Ranger Raptor

    You need to recalibrate via Forscan. GOAT Offroad website has the procedure documented. Just follow those instructions and your truck will feel like factory again. It is straight forward and easy.

  3. Michelin Member Product Testing, 2 Spots Available

    1. 2024 Ranger Raptor 2. 4-door. 3. 5ft bed. 4. Factory spray in liner. 5. No drop in liner.

  4. American Adventure Lab Ford Ranger Trailer Plug Tuck Kit Install

    I am going to need one of those too. I have been unable to complete my installation. I will buy the replacement plate, I just don't want to buy a complete kit.

  5. American Adventure Lab Ford Ranger Trailer Plug Tuck Kit Install

    Same. I just cannot get mine to set.

  6. OTA Recall 26C10 - Completed?

    Mine was updated on May 4th.

  7. American Adventure Lab Ford Ranger Trailer Plug Tuck Kit Install

    I have the kit installed, but the 7-pin connector will not clip in, so I haven't completed the move yet. I was looking to get some new clips perhaps.

  8. FMI upper control arms

    Yes, I had ordered the UCAs as well. It did take a bit longer than I would have thought to receive them, but I was not in a hurry to have them installed, so it didn't seem that bad.

  9. This is a Very Quiet truck

    I too had a Bronco prior to my Ranger. It is much quieter. But then again, I think I had a bad hard top as it was worse than my '15 Jeep Rubicon.

  10. Hardtop Ford Ranger: MAXLINER’s Venture Canopy For a Safer Journey

    Me too!!

  11. 🚨 New Product Launch – 2024+ Ranger Hood Deflector by TripleAliners 🚨

    RANGER Next mod would be the tailgate mat.

  12. Ford Procal Performance Tune Installed!

    I am lucky, my son-in-law is an ASE certified machinic. So glad that I didn't pay for the installation. After watching what was done.

  13. 🛠️ We Need Your Input | Choose the Rear Cup Holder Position!

    I think B is the better of the two.

  14. 🎁 TripleAliners Ranger All-Weather Mats Giveaway 🚙

    My Ranger is most often found in doing daily life activities. But it does enjoy getting out and going off-road as often as I can.

  15. Hardtop Ford Ranger: MAXLINER’s Venture Canopy For a Safer Journey

    This is the canopy I wanted for my truck. Was in chat with them before they came to the States about a color match to Hot Pepper Red. They told me they were working on it, then they just dropped it. Very disappointed. I think this canopy is one of the best if not the best one out there...

  16. What did you do to your Ranger Raptor Today?

    They are a +25 for the offset

  17. What did you do to your Ranger Raptor Today?

    Standard flares for the '24 Raptor

  18. What did you do to your Ranger Raptor Today?

    I have been collecting parts for several months now. Finally, everything had been installed. GOAT OffRoad 2”/1” puck lift. Method 703’s in Matt Black wrapped with Falken Wildpeak A/T4W’s FMI UCAs and Tie Rods. The Forscan recalibrate the ride sensors. Very straightforward. I used the document...

  19. GMF Trailing Arm Sensor Covors

    Have you seen these? https://www.foutzmotorsports.com/products/2024-ranger-raptor-rear-suspension-travel-sensor-guard?variant=46094294909140

  20. Rival bumper and skids + Foutz UCA, sliders and tie rods + GOAT spacers + 35" tires

    First off your truck looks awesome. I am going down a similar path. I have been collecting my parts. I have the GOAT 2"/1" spacers and the FMI UCA and Tie rods. Also decided on the Method 703 with +35 offset with Falken Wildpeak ATs at 35x11.5 R17. I will post pictures when completed, but I...



Top