Search results

That definitely looks odd. I've had the A-Pillar covers off but not the dash, I don't know if there's clips back there and yours is not seated down fully?

Do you have a link for this panel? I am putting a topper on and moving the air to the back bumper, looking for options to change up that panel.

Nice -- do you have wider shots of the boards when up and down?

I just finished installing this guard by Foutz Motorsports for the "active suspension control module" that sits on the frame on the driver's side near the rear suspension, about 1/2 way back on the back door on the driver's side. Here's the module with the stock guard plate. That large cable...

I wanted to add some extra USB-C ports in the center console to run a GoPro and just for extra charging. When I did my big audio upgrade, I removed the 12v port in the storage cubby and decided to re-use that for more power ports. It turned out pretty nicely, just used off the shelf bits and...

No cooling issues... it also gets hot here in Colorado 😄 -- dashboard showing temps of 110° in traffic or crawling in the desert in Utah. Seems to be plenty of airflow. At low speed it's going to be the fan doing the work anyway. Edit: I went to Moab earlier this week because I'm bad at...

WeatherTech makes a great set for the Ranger. Also they are made here in the USA.

Short answer is no. I would change the Ford UI to "dark mode" in settings in the truck so that it fits better visually with Android Auto, but that's just me. That center section is Android Auto. In this form factor of screen it will always show a nav app on top (Google Maps, Waze, OnX, etc)...

I was out in Moab over the holidays, Carbonized Gray is still the best 😄

Yes

The B&O sub in the raptor is like 5" or 5.5" -- just a lot of acoustic tubes in the housing, but the speaker is tiny.

Yeah the Kicker KSC350 fits in the dash center channel, but it's not plug and play. You will have to either directly wire it in or cannibalize the stock speaker's plug and solder that onto the KSC350. I used the stock speaker's plug, there's some notes on figuring out which wire is which over...

Please, please everyone stop quoting giant posts and adding a one-liner :) Not sure if you can get it done at the dealer, I would assume so, they certainly should be able to do it. They are the full tie rods, not the half ones.

Yeah if you are doing a dashcam and/or radar, I would just buy a mirror tap instead. Some other threads about where to hook in.

Do you guys have a link to the center caps? I bought at Discount Tire and just have the regular method caps.

Best wheels for this truck -- looks great!

For what it's worth, I have the engine, transfer case and gas tank skids. Transfer case went on without issue. Gas tank took a little fiddling but just awkward. Otherwise easy peasy.

Pretty sure it was @Freedom Chariot

Ooof, good times 😄 I had a similar experience with getting the winch to fit and getting the bumper aligned. Fiddled with the winch for a while and then at some point it just fell into the mounting bracket correctly. Spacing is super tight. Rotating the bumper forward was also an issue for...

I would also see if your dealership installed a LoJack or other vehicle theft system. These are wired right to the battery and are on all the time. I had the low power warning a couple months ago but have not seen it since. Tempted to swap for an Optima battery anyway.