Installed a Lomax bed cover

[Greatlakespilot]

I just put the same one on mine yesterday. I had one on my gen5 ranger for 5 years. I highly recommend it. Did you have any issue with positioning the rails so the lip of the rail sits on top of the bed cap?
https://www.ranger6g.com/forum/members/dubfound.6714/

Sponsored

 

[Dubfound]

I just put the same one on mine yesterday. I had one on my gen5 ranger for 5 years. I highly recommend it. Did you have any issue with positioning the rails so the lip of the rail sits on top of the bed cap?
https://www.ranger6g.com/forum/members/dubfound.6714/

At first it was sitting to high. Just had to adjust it a few times and tuck the rails down a little more lower. It’s almost water tight at this point.

 

[JrHDRanger]

I just installed my Lowmax Stance cover this morning. I opted for the carbon fiber version. I about did a double take when I pulled it out of the box. It was way lighter even than I expected and super strong. Very pleased. I had a BAK Revolver X4TS and hated it. It leaked and was built too short. This Lowmax is sleek and seals tight, way better design and attention to detail. Not sure I like the magnet roof mounts though, it’s kind of an eye sore. Not that anyone would really notice them, I guess I’ll get used to those. Overall extremely happy.

Sponsored