Hughy
Member
- Thread starter
- #1
So has anybody on here really played around with diy oem mods to step up the stx package to different varients?
When I had my 3rd gen taco, guys were going ham turning the base models into trds. Toyota pretty much used the same wiring harness for all models so you could pretty much much plug and play mods.
Just curious if ford went the same route and I could start scanning the junk yards for wrecked 6th gens and start upgrading my stx at a fraction of the cost.
I've been wanting to put all the bed outlet and light options on my stx, and maybe swap to the electronic seats.
When I had my 3rd gen taco, guys were going ham turning the base models into trds. Toyota pretty much used the same wiring harness for all models so you could pretty much much plug and play mods.
Just curious if ford went the same route and I could start scanning the junk yards for wrecked 6th gens and start upgrading my stx at a fraction of the cost.
I've been wanting to put all the bed outlet and light options on my stx, and maybe swap to the electronic seats.
Sponsored
