Smelly Dix
New Member
- Thread starter
- #1
I've had my new 25 STX for a couple months now and have loved it. Working in construction/project management, my backseat is always full of tools, plans/documents, coolers, sometimes even my travel printer. The backseat is great for the size of the truck but has still felt limited compared to my '13 F150 4door (duh) and I have done the full backseat delete on my old '08 with the suicide doors and loved it.
With a toddler now, I knew a full backseat delete wasn't feasible so I worked up my own 60/40 split cargo platform without ripping out the rear seat and keeping my car seat in full time for the kiddo. Figured I'd share with you guys as I haven't seen a lot of stuff like it.
So far very happy with it. I'm planning on adding some additional leg supports in the future and currently printing a cupholder I will mount behind the center console. Also have plans for an additional carpeted edge/trim to keep stuff from falling off.
Originally planned to use 3/4" plywood but went down to 1/2" (bought a 4x4 sheet rather than full sheet) and had some creative ideas for mounting the platform to the existing car seat brackets. Ended up securing a ratchet strap around the back instead for the time being. The goal was to be able to remove this easily if full backseat was needed/nothing permanently modified. Also I used a foam "seat leveler" to support the underside of the platform on the seat. I can link the specific one if y'all want. Just chapped the foam down to the length needed and slid the cover back on.
Let me know y'alls thoughts or if you have any questions.
With a toddler now, I knew a full backseat delete wasn't feasible so I worked up my own 60/40 split cargo platform without ripping out the rear seat and keeping my car seat in full time for the kiddo. Figured I'd share with you guys as I haven't seen a lot of stuff like it.
So far very happy with it. I'm planning on adding some additional leg supports in the future and currently printing a cupholder I will mount behind the center console. Also have plans for an additional carpeted edge/trim to keep stuff from falling off.
Originally planned to use 3/4" plywood but went down to 1/2" (bought a 4x4 sheet rather than full sheet) and had some creative ideas for mounting the platform to the existing car seat brackets. Ended up securing a ratchet strap around the back instead for the time being. The goal was to be able to remove this easily if full backseat was needed/nothing permanently modified. Also I used a foam "seat leveler" to support the underside of the platform on the seat. I can link the specific one if y'all want. Just chapped the foam down to the length needed and slid the cover back on.
Let me know y'alls thoughts or if you have any questions.
Sponsored