Recent content by Lord Vader

I hate to part with it. It's such a cool little truck! I have a Ram 1500 I was going to sell but decided to keep it for towing so I could keep the Ranger. Then my friend showed my wife his 5th wheel LOL. So we're now looking at 5th wheel RV's. I'm selling both trucks for a HD. Anyone...

With deep regret I must sell my practically new Ranger Lariat. I just purchased it in Feb and did a lot of improvements to it. Unfortunately it's not going to work for my needs. I plan on towing an RV that is going to be too big for this truck. I'm into this truck for $58000 and only asking...

Toyo only had LT tires in my size. I don't need LT's so I didn't want the added weight. The Nitto's had great reviews and they're very quiet and light weight. I'm very pleased with them.

Has anyone had an issue switching drive modes? When I turn the dial it often jumps through all the modes instead of going one at a time. I like to switch to sport mode and often it keeps going to the 4x4 modes. Then I have to turn the dial the other way to get it back to sport mode.

LOVE the tires! Almost as quiet as the stock tires and they aren't LT's so they're not much heavier. I like the look and you have 2 sidewalls to choose from.

100% RVL flares mount over existing flares. The removing of fasteners is the inside liner fasteners.

There wasn't any sensors on my fenders, just lights.

Thanks, the lugs got a little scuffed tightening them up, even without an impact gun but not too bad. They were cheap so if they get rough I'll just buy some more.

Thanks, I did install them myself. No drilling but I could not get the front 2nd hole in the front flares to line up on either side. It was off by a good bit. I just skipped them and they seem fine without so I haven't messed with them. The lights were kinda a strange deal. I was installing...

I haven't been in any messy situations yet with the new tires. Just installed them Friday. These flares have integrated mud flaps so I think they should perform well

Thank you! Sometimes less is more if you know what I mean. I can't believe the boards don't fit a 26! Did they change the BCM? Physically I'm sure they will fit. There's a plug that plugs in the OBD port and you have to tap 1 wire under the left kick panel. The instructions were very vague...

This area is really convenient for just about everything. 2 hours east you're at the beach, 2 hours west your in the mountains.

Those +25 wheels are about 1.18" out from the stock wheels you might be ok with that. My tires are really tall at 33.2" and they just barely rub the liner at the tread corner. If you get the 32.6" tires like 285/65r18 you'll be fine. I think all I need to do is pull the liner back a little...

I was just thinking this truck has no sound and I like the pipes out the back. I'd love to hear some different exhausts. I want a tune as well.

The spacers were to widen the stance. The fender flares made the wheels look too sunk in for my taste. I wanted the wheels flush with the flares. I have a slight rub at full lock that I think I wouldn't have if I didn't have the spacers. There are guys on here running the same size setup...