Search results

My problem was, I couldn't wait to launch it. Im sure that caused all my issues. It takes as lot of self control to stay out of it for the first 100 or so miles. Good luck out there and let me know if this helps

Go to this link for procal initial driving...

I have had throttle response issues and also shifting issues since the tune. I believe I have narrowed down my problems. I think i taught my truck bad habits early in the tune when the truck was still learning the driving and shifting patterns etc. Been living with it for a long while. I...

Saw a video on YouTube the other day of a brand new Bronco with a 6 speed stick in it.

Scitoo These were really inexpensive and no holes necessary. If you get sick of them, you can remove them no problem.

Looking for opinions on how this looks. Haven't seen any RR's with simple roof racks in the US. Please chime in good or bad.

I like subtle too, but there isn't any Procal decals anywhere and I like the Performance with the checkerboard look, so I felt I should make one. If anybody wants one let me know.

It comes with mount in the box. I have it mounted on left. The wire tucks in nicely down the side of the dash. I wire tie the extra cable under the dash. In the menu, go to Datalogging / Gauges to select the ones you want to display. Here's a couple pics.

If you get the Procal, there is a realtime psi gauge you can select to monitor oil pressure in numbers. It is showing higher psi than the factory truck gauges are on my RR. Idle is 35 to 40 psi. When I'm on it, it goes up above 60 psi.

Like this?

Looking for a vote on which ones you Ranger fans like the most.

What do you think was in the update. It clearly uploaded it and wrote over the previous performance file. Then when connected to the truck, loaded a new file. Sucks they don't tell us

Ok guys, bringing you up to date. After getting the update and writing it to the Procal, I went to the truck and plugged it in. I went to the cal section. I saw that both original and performance tunes were listed. Then I selected performance and got a message wrong vehicle or no file. Then I...

Im not sure what it does. I guess I will be the guinea pig here and let you know if I notice any changes or improvements. Stay tuned. Ha Ha...

I installed it three month ago. I just checked it today because I read online you should check it every 90 days. It's been working fine except for a few things. If I'm on a downhill incline and dump it, when going into 3rd, it falls on its face, then recovers. The trans doesn't seem to know how...

I just plugged in my procal to the pc and opened procal software. It found an update. I ran the update and it wrote the new file successfully. Not sure how to proceed. Do I reflash back to factory, then reflash the tune? I found the below online. Anyone out there done this? "As posted" Yes, if...

Let me introduce you to my little friend. Scranton area

I want to start by asking that you guys and gals, please don't see me as the whiney bitch on this forum. I have had this issue for a while. I will run the Max defrost for a few minutes right after startup, then when I turn off, I select the panel for air output. Even with the temp set down to...

Thanks for the help. I'm in PA and it's pretty cold up here. It gets even worse when it get below 20. I do warm the truck every morning for like 5 minutes. I will try to get some silicone on the seals to see if that helps.