Search results

I had the same issue and 2.3.66 did the trick

Worked for me as well, thanks! I couldn’t even connect with 2.3.65

Makes sense, but from what I can find online the 2.7L weighs between 155 and 175 pounds more, so just 80-90 pounds per spring. I may be willing to take my chances :)

I stopped by my Ford dealer and looked at a '24 Ranger on the lot, and the stake pocket cover matched the picture in their instructions, which is also the same as what's on my '25.

I just got this message back from Team Eibach: "I just noticed you have the 2.7L V6, which we have not tested yet. The current kit we have coming out was based on the 2.3L engine. Now I imagine it should fit the 2.7L V6 as well, but we will need to bring one in for testing to confirm fitment...

Mine was built the last week of February as well, so I wonder if anyone has seen this new 2025 stake pocket cover yet?

My X4S package only included the parts for a 2024 setup. According to BAK and their online manual, you follow instructions for 24 or 25 based on the stake pocket covers. My 2025 has the "24" stake pocket covers so the extra parts weren't needed. The 25 "kit" has a different bulkhead piece of...

Should we expect the rear vinyl edge of the X4S to rest on the top edge of the tailgate cap? I'm hoping that will be the case when my replacement cover ships.

https://www.nittotire.com/light-truck-tires/terra-grappler-g3-all-terrain-light-truck-tire/ I'm planning on going with these in a 275/75-18 once I get my front end leveled, on an 18x8 wheel with 41mm offset. I've been a BFG guy for my trucks/SUVs since my first 82 Ford Bronco, so this is gonna...

Have you reached out to BAK?

BAK is sending me a replacement cover in response to this issue and the email I sent with all the measurements. Not sure if they’re changing anything or if they just decided the one I got first was incorrectly built. Its supposed to ship on or before 4/25, so maybe they’re tweaking something...

I didn’t have any trouble with the clamps, and the rails went on just fine. It’s just the cover itself that doesn’t fit on my truck.

The D-seal that faces towards the rear barely contacts the inside of the tailgate, if at all. The Rear edge of the cover has no vertical support at all.

Good question but I have no idea

This is what they told me by email a week ago.

This is from the manual you can download from their site. My ‘25 matches the ‘24.

I contacted them about the ‘24 vs ‘25 instructions based on the stake pocket covers. My ‘25 has the ’24 stake pocket covers, and they said to follow the ’24 instructions. That was a good thing as my package only included the ‘24 parts.

Here is the measurement info included in my email to BAK support: Here are a couple of overhead photos that I just took. I also took measurements of the side rails and vinyl cover length from front to back, from just the front vinyl cover edge to the rear. On the driver side the rail is...

I hope they can figure out what's wrong with the design relative to the Ranger and ultimately send me the correct one :)

I just picked up my new 2025 Ranger 2 weeks ago today, and just this past Friday I installed the BAK Revolver X4S. At this time I would caution against ordering that product until BAK has a chance to figure out what's going on. I have supplied them with numerous photos and measurements so...