Strands Nuuk D-line 40” behind RR grill

[CHall]

2.5hr install so far. Still have to final wire everything. Probably be asking for wiring help after some searching.

Wanting smber DRL on with factory headlight DRL’s, Aux switch 6 or 1 turns on light bar and light bar lights up with high beams only and only if aux switches on.

Waiting on Signature Lux Amber DRL circuit boards before removing anymore parts again. Just ziptied wiring up out of way while wexwsit

Very happy with fit. Alignment of amber DRL with factory headlight DRL was the goal. Minor trimming necessary.

Sponsored

 

[HGHVLTS]

Looks clean, like the look, any way you could do some light output pics at night? Wouldn't mind seeing how they light up the road!

 

[entoptics]

Looks good!

How did you achieve the holy grail of tying the lights to high beams??? I’ve searched high and low for instructions. Even my Ford dealer couldn’t (wouldn’t?) help.

I've got the Altiq bar, and they were no help either.

Dog hits the AUX switch with her head every once in awhile, so I blind people too often. Even got pulled over for it awhile back.

Would love some details on the wiring recipe!

 

[CHall]

I have not completed the wiring. So far looks like pin 3 will be my trigger wire for high beams. Headlight Pin 6 will be DRL trigger. Also think I’ll forego using any factory upfitter switches and be wiring direct to battery with a 40amp fuse.

I’ll report back when I complete the permanent wiring.

 

[entoptics]

I have not completed the wiring. So far looks like pin 3 will be my trigger wire for high beams. Headlight Pin 6 will be DRL trigger. Also think I’ll forego using any factory upfitter switches and be wiring direct to battery with a 40amp fuse.

I’ll report back when I complete the permanent wiring.

Hope I'm wrong, but be prepared for disappointment.

I don't remember the exact pins I was instructed to use, but there was no 12V signal that comes/goes with the high beams on any of the pins when I tried to wire mine up.

Apparently the "Rest of the World" rangers have a different setup, and at least in Australia, the AUX6 switch is tied to the high beams from the factory, but not the NA Raptors.

There's supposedly a wire in the cabin somewhere (driver footwell?) that carries a voltage when the highbeams are on, but I've not found much information to locate/ID it.

Sponsored