Search results

From time to time, especially for our OEM projects in Europe or Australia, we conduct various strength tests: Deep Stamped Aluminum that is 1/4 inch thick proves to be three times tougher than flat steel protection. These tests involve applying a load of 3 tons per skid plate.

We apply a zinc-flake process to our fasteners and galvanize our aluminum skid plates before applying Akzo Nobel coating. As a result, no issues have been reported thus far from any market including humid and salty Asia and Australia.

There is no offer for a full set yet because we will be releasing skid plates one by one as we perform necessary modifications to our Australia market skids to fit US model. Engine skid plate has been already added to the website. Code RNGRFRM gives 10% off for members of this Forum.

Gas tank skid plate is mounted with 4 steel brackets that we supply.

Stock engine skid that has no oil maintenance access gets replaced.

10 lb engine skid 12 lb transmission skid 22 lb transfer case skid 26 lb gas tank skid

Holes locations , threads

Not sure about full sets, we will be performing some mods to 2 of 4 skids so those might take couple months.

Busy day here in TX today testing our Australian kit on US Ranger Raptor. We will be releasing engine and gas skid plates to the US market shortly, and then transmission and transfer case skids a bit later as there are minor chassis differences.

Yes, for Raptor we will be releasing 4 skids in total - engine skid (sits next to factory skid, replaces 0.1in thin steel one), transmission, transfer case, gas tank. Our 1/4in thick aluminum replacement for factory front skid is coming later this year.

So far so good on Raptor. Still not in the USA, but tested in Mexico and Peru. US Ranger Raptor is scheduled to be tested next week if not rescheduled. Anyone with “non-Raptor” Ranger around Houston/Dallas/Austin…. ?

nope, we don’t specialize in bulbars.

P.S. Previous face Ranger bumpers and skid plates. Complete incompatibility with the US version regardless similar apearance of a truck.

Yeah, as of today we are already supplying our aluminum gear for Next Gen Ranger in Australia, Asia and EU where they are all same. Based on our experience with the previous Ranger where US version was different from what we dealt with in other regions, we just keep our US inventory (yes, stock...

That’s in Philippines. We’re still to verify installation of front and rear bumpers and skid plates on US Ranger (non-Raptor).

OWN A 2024 RANGER (NOT RAPTOR) IN HOUSTON TX OR AUSTIN TX? HIT US UP FOR AN R&D COLLAB! Following our standard R&D process, we are seeking a vehicle to test install to verify on US Ranger and US Ranger Raptor our products 1/4-in. thick Deep Stamped Aluminum skid plates Aluminum Bumpers Hood...