Search results

Thank you for your service

Thanks for posting! I just ordered it.

I found it difficult to remove and definitely had to disconnect sensor wire. Replacing cover was also a challenge getting tabs fully seated so clamps could snap shut. Hoping second time will go better…

Only negative about Assault School was how uncomfortable the headrests made wearing the helmets.

Like the seat back on that truck!

I have some slack on driver’s side as well. It goes away when I place any weight on the tailgate. I believe this is due to the torsion bar. I suppose this could be tested by unhooking the torsion bar to confirm.

All I can say is WOW! What a work of art! Can’t wait to hear more…

John- Thanks for sharing! I see you have added an extension to your valve stem to be able to check pressure in spare without dropping it. If you install the spare protector, please share your approach for routing extension hose. Probably not that complicated, but I appreciate learning from...

I used some lock washers on mine. You can also shim with some flat washers, if you are fussy about the orientation of the eye.

I went with the black. Plenty of thread and I think they look better with spray in bedliner.

Congratulations! I recommend a spray in bedliner, but be sure to plug the threaded holes and maybe mask the tie downs. Wish I had gone the bed rug route instead of rubber mat (hard to slide anything in).

Handsome pup! Have you asked any of the contacts at the school? I’m pretty sure a lot of them live around Toelle and could point you in the right direction. Who knows, they might enjoy his company for the day.

https://www.tufskinz.com/collections/ford-ranger-2022-2023-aftermarket-accessories/products/rag028-raptor-tailgate-ford-ranger?variant=41146251116640

Have not seen stainless. I went with carbon fiber.

My previous truck was a Ridgeline Black Edition. It came with a great cargo net. You can buy the OEM Honda net from Amazon or a Honda parts source for about $100. Bed is similar size...

They were standard, at least on Raptors. Can’t speak to other models. Did the dealer do any kind of a bedliner? Might have been removed for that. I can tell you the bolts were brutal to remove due to lock tight on threads and spray in bedliner material in torx heads. Good luck!

Have you looked at the carbon fiber hood & side vents from Indi Carbon?

I’ve been very happy with it. You are not kidding, storage space is very limited. Also went with Ford swing out storage on passenger side over wheel arch. Plenty of posts on installation, especially if you have spray in bed liner. Two notes about the vault. Important to notice dial position...

My nephew (Bronco owner) loved it. We had a great time.

Impressive! I have a .308 that’s capable of 800 meters, but only have about half of that at our farm. Enjoy that beast!