Wolfman00
Well-Known Member
- First Name
- matt
- Joined
- Aug 5, 2024
- Threads
- 17
- Messages
- 156
- Reaction score
- 98
- Location
- crofton md
- Vehicle(s)
- 2024 xlt
- Thread starter
- #1
in the past i’ve experimented and now i’m switching to CAD for my modeling.
new idea still uses 1530 so all accessories that other manufacturers use will work.
grade 8 carriage bolts slide in the bottom, and sandwich the riser to the bed rail spacers, and bolt it down with a washer plate (that will be stainless.
i have these designed in 1” and 1/2” of rise. 1” ones should clear most roll up tonneaus that mount between the rails, but it will be tight for sure.
the riser will totally cover the stake pocket and with some 2mm weatherstripping it should be sealed, and look clean
i’m going to have the first set 3d printed with glass filled nylon. i may get some machined out of 6061 and powdered texture black later if i’m happy with it. (or maybe injection molding)
open to ideas and suggestions,
the idea to to make a stupid simple rack, that’s low, inexpensive and does a simple job like carry a tent. not as beefy as a full rack (the 6061 risers would be thought)
basically i’d sell the risers and buyers would get the 1530 bars from whoever they want/however the want etc.
here sample ideas-
new idea still uses 1530 so all accessories that other manufacturers use will work.
grade 8 carriage bolts slide in the bottom, and sandwich the riser to the bed rail spacers, and bolt it down with a washer plate (that will be stainless.
i have these designed in 1” and 1/2” of rise. 1” ones should clear most roll up tonneaus that mount between the rails, but it will be tight for sure.
the riser will totally cover the stake pocket and with some 2mm weatherstripping it should be sealed, and look clean
i’m going to have the first set 3d printed with glass filled nylon. i may get some machined out of 6061 and powdered texture black later if i’m happy with it. (or maybe injection molding)
open to ideas and suggestions,
the idea to to make a stupid simple rack, that’s low, inexpensive and does a simple job like carry a tent. not as beefy as a full rack (the 6061 risers would be thought)
basically i’d sell the risers and buyers would get the 1530 bars from whoever they want/however the want etc.
here sample ideas-
Sponsored
Last edited: