RangerTodd
New Member
- Thread starter
- #1
I have a Ranger Wildtrak 24.25 and have removed and put a commercial service body on. When I am working out of the service body I would like to be able to have the vehicle locked and the service body central locking unlocked.
Are there any FORSCAN or Ford Programming Tool gurus who know if the output of the roller shutter button on the key fob can be programmed to provide a secondary central locking output to control the service body locks seperate to the cab?
By default the output to the roller shutter would be open or close trigger (based on opposite of last use), wait for closed trigger and stop. As I understand it central locking is pulse in one polarity to open and pulse in reverse polarity to close.
Any help appreciated. To those who suggest a seperate fob and controller thanks but no thanks. If I am going to do that because the above is not possible I will build an arduino interface to convert the output from the roller shutter to meet the needs to control the central locking output
Are there any FORSCAN or Ford Programming Tool gurus who know if the output of the roller shutter button on the key fob can be programmed to provide a secondary central locking output to control the service body locks seperate to the cab?
By default the output to the roller shutter would be open or close trigger (based on opposite of last use), wait for closed trigger and stop. As I understand it central locking is pulse in one polarity to open and pulse in reverse polarity to close.
Any help appreciated. To those who suggest a seperate fob and controller thanks but no thanks. If I am going to do that because the above is not possible I will build an arduino interface to convert the output from the roller shutter to meet the needs to control the central locking output
Sponsored
