Shark Fin Gasket Not Sealed - Ranger Raptor

[donkey]

Anyone elses shark fin gasket look like this? When I initially pushed it down a bit of water came out lol.

Not a big deal, but I’d usually think a gap in that seal means water will get in if the bolt holes aren’t super tight. And no way to tighten it without pulling the headliner I’d assume.

Sponsored

 

[Wolfman00]

there are actually 2 seals on it. (mine was broke from the factory so it was replaced) there is an inner o-ring seal where it clamps down and then the outer gasket, which you see. yours is fine. but if you need pulling it you will deform the roof at the mount and then it will leak for sure haha.

 

[donkey]

Thank you sir!

Sponsored