Search results

... wow that's some negative value content. lol. Definitely Ai aggregated slop. fysa - the new hybrid TRD variant puts the batteries under the rear seat next to the 12v battery (so adiós underseat storage) plus, the special sauce pneumatic seat hardware on the rear of the front seats hit's...

Data acquisition is a big part of vehicle design - if you mod or adjust the vehicle it's logged in-vehicle (which can typically used in defence of warranty claims). With expanded CAN bus implementation the logging now reaches the periphery of the vehicle: modem or not. So if it's a...

3 features I love : both within the Raptor's drivers tft. #1 is the assignable gauges ( 2 up top and 2 larger in the center) this works out well as I'm a fan of the trans and oil temps / pressures and volts. #2 And when that's not needed: I use the "Calm" screen on long pavement stretches...

Couple of things (total is <100 bucks) you can do on your first week of ownership. First - If you have the Rngr/Rptr and you go off trail - you'll be super happy spending $45 bucks and about 40 minutes installing the Adventure Lab trailer plug relocate kit. (I'll admit to happily grinding off...

Considering taking the Ranger Raptor for a run south in the NORRA 1000 Safari Expedition. Haven't done a long, remote week long off road trip in this vehicle - only weekends out. This is my first American vehicle in decades fyi & I thought I'd ask all of you what's prone to failure in the...

Not to get too far off topic, what's the ET on your Roush rims? I was considering 35ET on some Methods @ next tire change. *agree on your PPF coverage fyi / vanity factor. Lol.

Well on one hand, I'm glad it's just not my unit specifically / on the other hand it's a bit of a bummer about the thin paint issues (seemingly industry wide in domestic vehicles) I was originally thinking I'd just use the heck out of the truck and then re-spray it down the line (for about the...

Has anyone noticed their 2025 Oxford White paint seems to ding or chip very easily? I've only had my RR since July and there are several spots (inside door frame, door handles, leading edges of front of truck by headlights etc) where small paint chips reveal a dark primer. They're small, so...

Coming from post Toyota and a JLR 110 Defender (20+ variant) - I'm going to give a nod to Fords interior on the 25" RR. It's really solid, quiet and the materials have gotten much much better. (my brother has a 17' F-150 Raptor and his interior isn't as nice - even when new - but it's our...

... yea, we'd previewed the trail before blazing a few sections. 🤣

... a couple of things I didn't notice in anyones list and you might consider. Stainless steel zip ties (in addition to standard plastic ones) Even just a handful... SS racing wire * easy to stash a couple of meters, wrapped around one handle of vice grips. * duct tape, wrap a meter or two...

There are some newer graphics by independent fanboy designers out there ... some are quite good and more modern/updated. fyi - I debadged everywhere I could, it's a look I like. fyi2 - if you wind up in the desert with Ocotillo & scrub on both sides of your truck ... (or even a tight...

I made a point to watch for all above - fyi : I've noticed it before (ex. hwy 40 driving from Mojave over to Flagstaff and then up to Durango ) - again really consistent roads and was repeatable. To bigb's point above : looks like it's a compromise between "aero" closed mode and "ac" open...

Ok - had a long drive today from St George UT over to Santa Monica. Had some long runs where temps were steady at 91 degrees and speed on cruise control was set at 80. I have both transmission and engine oil temps selected in my view gauges pack. ... over the course of the day I noticed (and...

SCC1 / Diode Dynamics.

No, the M&R mounts uses the two bolts just ahead and outside of the vane system (similar to other behind-the-grill light bars) - the mount's pass through the front grill hex pattern. No cutting required. *you'll spend more time on removing the bottom trim just below the grill than anything...

... wired up the M&R 40" light bar, added factory splash guards, and got in the first oil change. (all super easy diy.)

... not quite today but just got around to posting a fun little blm road near Capital Reef.

What's needed is a "camp mode" in the car programming module. Something where opening any door (except the drivers door) lets you in and out without triggering all of the lights or powering up the pre-start program (leaving the vehicle in extended, low-power mode)

Thanks everyone / looks like Forscan is the way to go. 😎