Search results

I would agree with this. When I was reviewing other posts about this, I don’t recall seeing anything that would make these incompatible.

Literally a place to clamp stuff down. I would not put a lot of pressure.

If your interior is black, these are almost a direct match. My wife, who is the Fine brush person in our relationship, said that the pattern was almost in distinguishable. I bought them from a Ford dealer. I think I paid $85 for the two including shipping. The part #s are the same for both...

Should try and grab the upper glove box if it is still available.

I bought them from Vinyl Fox. I paid $65 but that included the set up fee. They have them on the website for $45 including shipping. I think this is the link...

So what happens when it reaches the “point”? I get some overflow in my truck bed? Like I said, 2 years and no issues. I can live with that. My factory spray in bed liner doesn’t have holes in it.

2 years - jit’s never once been an issue.

I have a FORD Rev cover which is a 4 panel cover. But I think it’s similar to one of the BakFlip

I used the area under the rail rather than drilling through those plugs. Drilling through the plugs is the recommended in the instructions. I didn’t want to drill them because they were covered with factory bed liner. Been like this 2 years with no issues.

So this morning I went out and disconnected the battery for about 20 minutes. Hooked everything back up and all the warnings went away and my screen is working!! Battery voltage is 12.4 Obviously, if it happens again, I will have to take it to the dealer. But thanks for the suggestions. Seems...

The infotainment system on my 2024 XLT is black. I have tried the hard and soft reboot that I found on Google, neither of them worked. I am also getting an auto hold system fault message. It also seems that my seatbelt warning is popping up kind of random randomly. All of this is new since I...

eBay, $60 including shipping. Now I have to figure out where to store it.

My running board lights and bedside step lights are tied into the same setup.

I spent a bit more on this. But it is hooked up to a wireless remote, when you say it is wired into existing bed lights, what triggers them. What trim is your truck?

You are welcome! I tried but taking pins out of the block is beyond my comfort level. I wound up running lights for the bed, running boards and bed step lights from the battery. I have a wireless switch on my keychain. There is another one by the tailgate and a 3rd in the little cubby to the...

Okay, I think this is the actual link https://share.google/xpg32Da71wdR83uN1

Okay it is easy enough to find if you know what you are looking for. I have a pdf of the file but I can’t seem to share it on here. Reach out to me in a PM so I can get an email address. Or put in the part # in the picture in google, no dashes and the word “installation” you should get the...

Just saw an up to $500 savings email from them today.

No, not reflective at all, but I have a light bar above the bumper that gets a lot of visibility.

The other alternative is to buy the aftermarket units for around $300 and pay a body shop to install them. I checked with a local shop (after the fact) and they told me about $250. I did them myself, took about 7 hours but I was 68 at the time so I don’t work as fast as I used to. My knees don’t...