Arizona 2025 Ranger Raptor Stock Running Boads

[JimG]

1 set of RR running boards taken off my 2025 RR. Taken off with 350 miles on the truck. Replacement cost from Ford is over $4,000. Today they’re in Montana, next week they will be in the Phoenix valley. These are easy to ship. Quotes to ship from Montana to Texas is about $225. Asking $1,500 or reasonable offer.
Thanks for looking.
Cheers!!!

Sponsored

 

[CACTUSGREYFX4]

Those are some nice toes

 

[JimG]

Those are some nice toes

LOL. Thanks. I was a toe model in my younger years

 

[ZombieDropper]

Mine had less than 20 miles on them when I took them off my 2025. I struggled to sell them for $300. Good luck to you.

 

[megamillionDeluxSlime]

I agree with the last post .. have seen them sell for 275-500$ and the higher they were the longer they sat until the price was dropped. I’ll give you 600$ shipped to Indiana.

 

[megamillionDeluxSlime]

I’ll give you 600$ shipped to Indiana …

 

[JimG]

I’ll give you 600$ shipped to Indiana …

While I understand you don’t have to buy, I also don’t have to sell. That can make putting a deal together difficult. I would accept $600 but you pay the freight. Any less than that I would rather keep them just in case I need to put them back on. Thank you for your interest.

 

[whale]

Just got my '26 RR, and the running boards are in my way. I will probably ruin the left bolster of the driver seat. But, they are so protective of the rocker panel and lower sides that I plan to keep them. Unless someone has an idea? CW

 

[25PlatTrem350]

If there was/is a reasonable way to cut them so they only stuck out half the width that they do I would happily do so and put them back on but because they stick out so far and our RR isn't really high enough to need them mine will stay off.

I installed a set of Ford Performance mudflaps that should "help" protect the sides but I'm sure they won't do nearly as well at that as the factory running boards do. Really wish the damn things weren't so friggen wide.

I've been looking at lots of different rock sliders/rock rails but I haven't found any that I like how they look so I'm still looking......

 

[superj]

that is why they are so popular to the non-raptor guys. those steps stick out farther then aftermarkets ones and are sturdy so they make a great step for the wife and kids.

 

[whale]

If there was/is a reasonable way to cut them so they only stuck out half the width that they do I would happily do so and put them back on but because they stick out so far and our RR isn't really high enough to need them mine will stay off.

I installed a set of Ford Performance mudflaps that should "help" protect the sides but I'm sure they won't do nearly as well at that as the factory running boards do. Really wish the damn things weren't so friggen wide.

I've been looking at lots of different rock sliders/rock rails but I haven't found any that I like how they look so I'm still looking......

I heard you can apply clear protective tape on the side.

Sponsored