Help ! Can’t not change drive modes & steering wheel buttons do not work

[megamillionDeluxSlime]

So I will admit I’m not very good with computers . Thought I saved as built files each time , but only have BCM , IPC on my computer . right now these are the DTC’s I’m getting
PCM - U0422:00-2F
iPMA- U0429:86-2F
IPMA- U2108:68-2F
IPC- U0212:00-0A
Truck will drive but can’t not change the drive mode & the steering Buttons do not work . Can anyone help ? I went to motor craft and downloaded the as built files but I think it is only given me 2 as built files .

Sponsored

 

[Don Vandyke]

I'm not expert that's for sure. If it was my truck i would disconnect the battery for 15 minutes.

 

[megamillionDeluxSlime]

Was going to do that this morning. It is raining out at the moment. Thank you for the reply

 

[RonM_TX]

Was going to do that this morning. It is raining out at the moment. Thank you for the reply

You may want to reach out on the F150 forum for ForScan support. There are a couple of members over there that might be able to steer you on the correct direction. They would know about downloading as built files from Ford.

 

[Don Vandyke]

So I will admit I’m not very good with computers . Thought I saved as built files each time , but only have BCM , IPC on my computer . right now these are the DTC’s I’m getting
PCM - U0422:00-2F
iPMA- U0429:86-2F
IPMA- U2108:68-2F
IPC- U0212:00-0A
Truck will drive but can’t not change the drive mode & the steering Buttons do not work . Can anyone help ? I went to motor craft and downloaded the as built files but I think it is only given me 2 as built files .

Any update??

 

[megamillionDeluxSlime]

Can change drive modes , but my steering wheel has lost signal with a few modules .

Sponsored