Truxedo Pro X15 Soft Roll Up Tonneau Cover - Installed

[telenerd]

Picked up the Truxedo pro x15 cover. Fits great! Low profile and looks good. Canvas type material and it has life time warranty! I had to stretch cover a bit after it heated up from sun. This is a before shot, fits flat now and zero wrinkles.

Sponsored

 

[willy]

looks good. i bought a similar one, Tyger T1 soft roll up. easy to install and lightweight.

 

[Rufus]

I just ordered this last night and it shipped today…can’t wait!

 

[telenerd]

I just ordered this last night and it shipped today…can’t wait!

Make sure to pickup the tailgate seal too. I’m gonna test cover tomorrow on 40 miles of high speed dirt roads to see if I get any dust in the bed.

 

[Wildo]

Is there certain one we have to order for the RR, or one size fits all? I supose it works with a sprayed in bed liner?
thanks

 

[FreezingFlatlander]

Make sure to pickup the tailgate seal too. I’m gonna test cover tomorrow on 40 miles of high speed dirt roads to see if I get any dust in the bed.

Have had several Tonneau Roll Bed Covers over the years with tailgate seals and without but always end up with lots of dust in the box. Please let us know your experience.

 

[telenerd]

Is there certain one we have to order for the RR, or one size fits all? I supose it works with a sprayed in bed liner?
thanks

Pretty much a one size fits all seal. I used the truxedo truxseal.

 

[telenerd]

Have had several Tonneau Roll Bed Covers over the years with tailgate seals and without but always end up with lots of dust in the box. Please let us know your experience.

Just got done. There was a small amount of dust in the back of the bed and some very minor dust in the front. I’d imagine the dust in the back was caused from all the holes in the bulkhead. Overall not bad at all. I bet if I was to seal all the holes in the front bulkhead there would be very minimal dust. I’m waiting on built right to release some accessories for bed molle before I seal the entire bed.

 

[Rufus]

Just got mine in the mail today. I hope it’s straightforward to install.

 

[telenerd]

Just got mine in the mail today. I hope it’s straightforward to install.

I had to trick my rear seal on cover. I close the tailgate and used a thin piece of cardboard to put the seal lip on back of tailgate. Now the rubber has sat for a few days it allows me to close the tailgate and have the seal on top of tailgate.

 

[telenerd]

Just got mine in the mail today. I hope it’s straightforward to install.

Check this video out.

 

[yoopercharged]

Check this video out.

That’s my video, thanks for sharing!

 

[Snkrjeff020]

Nice. This is the cover I plan on getting.

 

[Axg1040]

Just purchased the X15 from Realtruck.com and the smaller adhesive foam pieces were missing. They are shipping them out but was hoping to install it this weekend after I bought it home tomorrow. Might just check a big box store for foam I can trim.

 

[eyelise]

Just curious how this differs from the Lopro on the Ford access site?

Sponsored