Solutions for raising driver's seat

[cc1999]

Good luck with your mod. I brought ones for the front. I only used half of them and was very impressed with the quality of the parts.

Thanks, I bought two sets, but I am planning on trying a couple on the back of the driver seat and see how that feels, it works like I think it will, I will be putting the other set on my other RR driver seat.

Thanks again for the link and info on these.

Sponsored

 

[ATestBishop]

I cut and drilled 2 pairs to use on both front seats to lift the front brackets up from a small aluminum billet, it was quite the hack job to be sure but even ignoring any sloped contouring they are solid and flush front and back. I can check thickness but is was 6-7mm I believe

 

[The Lone Ranger]

Awesome!
Thanks!

Looking forward to trying these out.

Order placed.

 

[The Lone Ranger]

Keep us posted on how the install went.

 

[BigBassDaddy407]

Would like to raise the driver's seat 3/4"-1". Desert Does It says I will need two sets of their seat jackers to do this - $169.99. Seems pretty pricey for a handful of spacers. Any alternatives ?

You might be able to unbolt the seat and stack a bunch of relatively wide washers underneath, then bolt it back down. Might need longer bolts. I've never looked at them though.

 

[The Lone Ranger]

You might be able to unbolt the seat and stack a bunch of relatively wide washers underneath, then bolt it back down. Might need longer bolts. I've never looked at them though.

I ended up using some composite material (UHMW I believe it is called) made for pads for boat trailers and other things. Cut them to length and drilled holes. Since I have a Lariat, I didn't think I needed the slant like on new ones you can purchase, since I can adjust front up with power seat control if needed. Bought longer bolts - install was easier than I expected.

Sponsored