I couldnāt find any official sources but I read around tonight and found some credible-sounding explanations. It implied that there was a normal controller responsible for the chime, blinker, and various alert noises but also a totally separate controller that can act like a backup in case the...
If you wait long enough all of the software-based recalls seem to have become available over-the-air so no dealer visit required.
I got burned with a 2021 Ranger when they had to drop the headliner to fix a piece attached to the roof: Put a hole in the fabric and then tried to fix it but made...
I did not notice this after the ITRM update but I may have an explanation for what youāre hearing: I think many modern vehicles primarily rely on the same speaker system as the radio, etc. However because some noises are safety-related they have a backup audio path with its own speaker if...
My reading of the BCM update notes is that what youāre describing is the behavior itās meant to fix: That the BCM interpreted activity during software updates (probably even of other controllers than itself) as a fault and logged a trouble code. So hopefully this was the last time and future...
Do you know what the tongue weight of those trailers are when loaded how youād use them? The general target tongue weight is 10-15%, so assuming itās in that range then for a 5,000lb load the low end of that range would basically be the Raptorās max rated capacity with no margin.
I canāt predict what will happen if theyāre unplugged or continuously covered but I do know that in my narrow garage before Iām finished parking it throws an error about sensor being blocked and shuts off the whole system: Front and rear sensors plus cameras.
You must have a bigger garage than me :). They have the same purpose as the parking sensors on the front and back bumper but they add coverage of the sides of the vehicle. If you pull into a very narrow spot youāll see the orange or red bars appear on the screen along the sides of the vehicle...
I donāt remember if it was default or had to be enabled with a menu but my Lariat shows that large center view when very close to the turn and upcoming turns further out go up between the 4 gauges at the top.
Are new folks continuing to receive the Sync update? Iāve been checking since it was reported here and still donāt see it. Curious if itās just a slow phased roll out or if itās exclusive to some particular trim level like the RR. Mine is a ā24 Lariat.
Iāve gotten a couple OTA updates in the last few weeks including this one but they seem to be prep work leading up to the Trailer Brake Controller update and not the TBC update itself yet.
Best to check the headlight housing for that specific badging but I believe Iāve read here that in MY25 or MY26 they stopped including the hardware support for the āmatrixā capability in the US. My US market MY24 Lariat has it and it works with the Forscan changes documented.
Best of luck! The people selling wheels commercially there seem to want the most money and I found often the photos werenāt of the exact set youād be buying. The set I found was a private seller who just got their own deal on bigger tires for their Bronco and needed the old set to stop taking up...
I am skeptical this is the case. I had a car with HID projectors where you could see the motion of the light as something physically moved when you turned the high beams on. My ā24 Lariat doesnāt look like that at all. In fact it has the cute feature where auto high beams fade in imperceptibly...
Whenever you do hook it up to a trailer you plan to use the guidance/assistance with Iād recommend setting aside some time. As I recall you have to do some measurements to know where to place the sticker, you have to answer a bunch of questions and enter some other trailer measurements, etc...
I havenāt triple-checked the manual to confirm, but pretty certain that āguidanceā vs. āassistanceā are just two modes of the same feature. As far as Iāve heard both always exist together on the 6G Ranger. Guidance means you turn the steering wheel yourself and the screen shows a visual of how...
So the takeoffs came with TPMS installed but you had the tire shop swap over the sensors from your original rims? Why? I just installed the takeoffs as they came and after a few miles the truck relearned all the new sensors.
Running at the recommended psi may be less comfortable but thatās part...
How was the tire shop involved? Had the seller dismounted the tires from the rims to remove the TPMS sensors?
In my research I found that the 5th gen Ranger Tremor (same tire) and Bronco Black Diamond both called for 39 psi on their door stickers. My 2024 Lariat with factory Goodyear Wranglers...
Iām curious what you feel is the right inflation pressure for those. I have the same rim and tire takeoffs and tried calculating the correct PSI objectively but it ended up feeling too low while driving.