Fix4Dirt 2024 Ranger Build

[HighDesertRanger]

Thank you! I swear I thought I saw a reply asking about fitment- I left rake in the system when the Dobs coils were installed, so it rubs at full lock right now. But Im 99% sure if I just adjust the coil preload it will be fine- stay tuned on that one.

Yeah, that was me too. I misread and thought you’d put the 35s off the Bronco in there. Then I realized those were 33s. Reading is fundamental

Sponsored

 

[Fix4Dirt]

Yeah, that was me too. I misread and thought you’d put the 35s off the Bronco in there. Then I realized those were 33s. Reading is fundamental

No worries! We all do that

 

[cc1999]

33s, Bronco Squatch wheels, and MBRP catback installed!

Looks great!
Love the SAS wheels !!!!

 

[Fix4Dirt]

Thank you man! Its a super sweet rig couldnt be happier

 

[ggsm111]

Lighting: Used Auxbeam switch panel, ran my GMRS antenna coax thru the port too.

Used 2" Alluminum plate to mount the fuse panel and breaker. Only mod to the auxbeam stuff was to crimp and solder a 90 on the positive side, since it wouldnt fir the cap.

Love your auxbeam install. For the plate you have holding the auxbeam fuse box, how did you mount it to the truck? I see a factory threaded hole im guessing you used to hold the right side so was hoping you knew the thread size. what did you do on the other side?

 

[Fix4Dirt]

Love your auxbeam install. For the plate you have holding the auxbeam fuse box, how did you mount it to the truck? I see a factory threaded hole im guessing you used to hold the right side so was hoping you knew the thread size. what did you do on the other side?

Hey man thanks for the quesrion! I dont have the rig with me at the moemnt but Ill be sure to get back to you when Im back with it again.

 

[Fix4Dirt]

As I recall I ran the bar stock far enough back that it reached another hole if memory serves me right

 

[ggsm111]

Lighting: Used Auxbeam switch panel, ran my GMRS antenna coax thru the port too.

Used 2" Alluminum plate to mount the fuse panel and breaker. Only mod to the auxbeam stuff was to crimp and solder a 90 on the positive side, since it wouldnt fir the cap.

Where did you hook the ground wire for the auxbeam to?

 

[Fix4Dirt]

Love your auxbeam install. For the plate you have holding the auxbeam fuse box, how did you mount it to the truck? I see a factory threaded hole im guessing you used to hold the right side so was hoping you knew the thread size. what did you do on the other side?

Hey dude sorry to take so long to get back to you I hope this helps. I took pictures of where the plate is mounted to.

 

[Fix4Dirt]

Where did you hook the ground wire for the auxbeam to?

Sorry also for a late response. I have a pocture attached where it comes out of the fuse panel and its wrapped around and geounded to the bracket as shown. Hope this help!

 

[Fix4Dirt]

Heres a picture of the panel and the ground cable comes down and around.

Sponsored