New member, black Ranger Raptor w/ mods so far

[midnight270]

Yup, they just have a pin that locates them on either side, pull or push it in the center to bow it, and it’ll pop right out.

Thanks! I'll take some pictures of mine when I try.

Sponsored

 

[CrankCase]

Thanks! I'll take some pictures of mine when I try.

Too bad you’re not closer, be glad to help you.
let me know if you have any questions

 

[Buckster]

Thanks for sharing. Which switch controller do you plan to use for lights/accessories?
Looking forward to following along for the updates on your mods.

 

[CrankCase]

Thanks for sharing. Which switch controller do you plan to use for lights/accessories?
Looking forward to following along for the updates on your mods.

I’m going to use a Federal Signal 200w Pathfinder controller/amp with OBD integration, so I can have auxiliary brake lights, turn signals monitor door opening to trigger side white lighting etc.
Hooefully by the end of next week I will get it all completely installed and programmed.

 

[CrankCase]

So some updates today.

I made a “custom-ish” half bed rack. I used 2 bed cross bars from @American Adventure LAb and a basic mollie panel from Rough Country I grabbed off Amazon.

the light bar in between the bars is a 1’ Federal Signal DynaFlare warning light. It is a red/blue/amber light and fully controlled through the main control unit.
I spaced it off the cab onto the OEM bed mounting locations, I plan to mount some rotopax to the bed bulkhead, and they will fit the space perfectly.

I also added a Decked box and got some lighting installed. Will try and get it all programmed this week and share some videos.

 

[midnight270]

What's up with your third brake light?

 

[CrankCase]

This? LOL

custom done. They are smoked flush mount tri color lights, red/blue/amber outers and red/blue/white
the lighting controller will control the lights and have the red active at 6% intensity when the headlights are on, so basically marker lights like the full side raptors. Hit the brakes and they brighten up for brakes. Open a door, the center one turns white for the cargo light. Flick a switch and the 2 outer amber turn on for chase lights.
Then the blue is part of the warning light functions.

I also added tinted tri color flush mounts to the front and rear flares.

red/blue/white on the rear, white will come on in reverse red is marker at a dim level and red and blue for warning.
front is blue/amber/white, amber for marker, white for scene and high beam trigger, blue for warning.

Give me a couple more days and I will have it all finished up, programmed and get some videos. LOL

here is where I mounted my controller

Sponsored