Overall Height Ranger Raptor

[jordantii]

Does anyone know if the overall height listed in the 2025 Ranger Raptor Tech. Specs includes the antenna? This is what it says "Overall height 75.9". If it is, I can get the stubby antenna and cram it im my garage.

Sponsored

 

[Flak]

I think it doesn't, if I remember right. I measured this dozens of times pulling the truck in a few inches more each time and praying, have to clear an I beam that's low in my garage. I actually had to get a stubby jr because antenna could actually hit part of my garage door if I was exactly centered.

 

[midnight270]

My single car garage door is 80 inches tall. The truck fits with a stubby antenna. It would rub the door going in with the stock antenna.

 

[Glisch]

My single car garage door is 80 inches tall. The truck fits with a stubby antenna. It would rub the door going in with the stock antenna.

This seems spot on. Just did a rough measurement of mine, its ~75 inches without the antenna. Then the factory antenna sticks up 5-6 inches above that.

 

[jordantii]

My single car garage door is 80 inches tall. The truck fits with a stubby antenna. It would rub the door going in with the stock antenna.

My door is at 77 and I just ordered the stubby. I guess I'm gonna try it this weekend.

 

[jordantii]

This seems spot on. Just did a rough measurement of mine, its ~75 inches without the antenna. Then the factory antenna sticks up 5-6 inches above that.

75 inches to the fin? I know it's a rough guess.

 

[Glisch]

75 inches to the fin? I know it's a rough guess.

Yeah, top of fin is right about 75in. I just held a level across the fin and dropped a tape measure down to the floor to get the measurement. Not perfect, but close enough. As long as the stubby antenna isn't bigger than 3 inches or so, I think you will fit. (it angles backward, and starts about an inch below the fin)

 

[jordantii]

Yeah, top of fin is right about 75in. I just held a level across the fin and dropped a tape measure down to the floor to get the measurement. Not perfect, but close enough. As long as the stubby antenna isn't bigger than 3 inches or so, I think you will fit. (it angles backward, and starts about an inch below the fin)

Cool, thanks. I'll have the stubby tomorrow and I'll report back. I hope it fits. Lol

 

[Flak]

Measured it again, my I-beam is 77.3" tall and the truck fits under, looks like the shark fin would but not the antenna.

 

[jordantii]

Measured it again, my I-beam is 77.3" tall and the truck fits under, looks like the shark fin would but not the antenna.

Oh this is promising info. So do you think the stubby will work?

 

[Flak]

Oh this is promising info. So do you think the stubby will work?

With Stubby Jr (I think thats the smallest one) it looks like its maaaaybe kissing 78" ish. I mean the problem is when you're getting down to those numbers angle of approach from driveway onto garage slab, tire pressure, etc... shaving mms off your clearance at that point

You might be able to squeak it by with the Jr at 77, I'm eyeballing it because my truck doesn't go in that far. You should be fine with the truck body, just pull it in slowly and check IMO.

 

[jordantii]

With Stubby Jr (I think thats the smallest one) it looks like its maaaaybe kissing 78" ish. I mean the problem is when you're getting down to those numbers angle of approach from driveway onto garage slab, tire pressure, etc... shaving mms off your clearance at that point

You might be able to squeak it by with the Jr at 77, I'm eyeballing it because my truck doesn't go in that far. You should be fine with the truck body, just pull it in slowly and check IMO.

Yeah it’s gonna be tight and I have the Jr. arriving tomorrow. I measured from the garage slab so we shall see. Fingers crossed

 

[Tuna]

Not sure it really helps, but Ford´s Body and Equipment Mounting Manual (BEMM) chapter 1.11.9 indicates a height of 1926mm (which equals 75,83") for the Ranger Raptor Base Kerb Weight, measured at antenna base.

Of course it also says dimensions are subject to manufacturing tolerances and refer to minimum specification models and do not include additional equipment.
Ans height dimensions are for guidance only...

 

[jordantii]

Not sure it really helps, but Ford´s Body and Equipment Mounting Manual (BEMM) chapter 1.11.9 indicates a height of 1926mm (which equals 75,83") for the Ranger Raptor Base Kerb Weight, measured at antenna base.

Of course it also says dimensions are subject to manufacturing tolerances and refer to minimum specification models and do not include additional equipment.
Ans height dimensions are for guidance only...

Yeah, thats what the tech specs says as well. I'll try it and see. If it does not fit, i'm gonna move...

 

[Chuck2001]

Stock RR with stubby antenna, I fit eveywhere, even downtown interior parking that says 1.95m maximum. It's tight ; first time I had my head outside the window like a dog to take a good look.

Sorry I'm metric...I don't measure stuff in thumb's width

Sponsored