Tonneau cover shopping today

[452Ranger]

Just remember that with any tonneau that doesn't fully cover the bed rails that water will enter thru the bed caps. You need to use silicon or some other type of sealer around each bed cap to keep the water out.

Hope this helps.

Sponsored

 

[wlarsen76]

I'm researching the EGR Rolltrac. I guess they are sort of big on the Ranger Raptors in Australia. I'm trying to find out if they are compatible with the Yakima Overhaul HD system. I'm also a little wary about drilling, but I figure I can probably get rubber plugs to make it look nicer if I every remove the cover.

 

[JrHDRanger]

I ordered a lowmax. I chose it because it does not have a foam core, or need for drain tube. Apparently the covers with a foam core absorb moisture after time and become really heavy.

Any tips for installing. I installed mine a few weeks ago and it isn’t tight when I close it especially in the back, I can move it up and down. There is a gap between the clip on the cover and side rail where it clips under. I have reinstalled the rails multiple times and the ribbed clamps that hold the side rail can’t go any higher. The rails are level. I thought about somehow attaching some kind of shim under the rail to take out the space and hold the clip on the cover firm to the rail, but haven’t come up with a good way to do that.

 

[greaserman]

Any tips for installing. I installed mine a few weeks ago and it isn’t tight when I close it especially in the back, I can move it up and down. There is a gap between the clip on the cover and side rail where it clips under. I have reinstalled the rails multiple times and the ribbed clamps that hold the side rail can’t go any higher. The rails are level. I thought about somehow attaching some kind of shim under the rail to take out the space and hold the clip on the cover firm to the rail, but haven’t come up with a good way to do that.

Wish I could help, but I can't. I had mine installed where I bought it.

Sponsored