Which tonneau cover: hard tri-fold, soft, or soft tri-fold?

[Uncle Buck]

I went with the soft cover. After discount codes and my used points I think I paid a little over $200.
I had one similar on my 2003 F150 and it lasted 240K with no rip or tears, just had to replace a few broken snaps. I like that the entire bed is accessible when rolled up as opposed to a trifold.

Sponsored

 

[SolarWinds]

What about a hard roll up unit?

https://realtruck.com/p/bak-revolver-x4ts-tonneau-cover/

 

[superj]

That might be the best of both worlds

 

[ecoope]

OK, so I went with the hard tri-fold from Bison. I actually wanted the soft tri-fold as I think the soft covers look nicer and they are a lot cheaper. But when I discussed with them, it turns out they don't have a soft tri-fold for the 24-25 Ranger. Just soft roll-up or hard tri-fold. They expect to have soft tri-fold available in a month or two. I decided not to wait, and ordered the hard tri-fold. More than I wanted to spend, but far cheaper than the Ford version. $US500

 

[ecoope]

OK, so I went with the hard tri-fold from Bison. I actually wanted the soft tri-fold as I think the soft covers look nicer and they are a lot cheaper. But when I discussed with them, it turns out they don't have a soft tri-fold for the 24-25 Ranger. Just soft roll-up or hard tri-fold. They expect to have soft tri-fold available in a month or two. I decided not to wait, and ordered the hard tri-fold. More than I wanted to spend, but far cheaper than the Ford version. $US500

Free shipping in Canada too...

 

[ChronciallyChronic]

OK, so I went with the hard tri-fold from Bison. I actually wanted the soft tri-fold as I think the soft covers look nicer and they are a lot cheaper. But when I discussed with them, it turns out they don't have a soft tri-fold for the 24-25 Ranger. Just soft roll-up or hard tri-fold. They expect to have soft tri-fold available in a month or two. I decided not to wait, and ordered the hard tri-fold. More than I wanted to spend, but far cheaper than the Ford version. $US500

Sounds like a very good price.

 

[superj]

yup, doesn't sound bad, at all

 

[TXford]

I’ve use Extang tri folds for years on numerous trucks. I’ve never had a security issue, although a knife could allow forced entry.
My current issue is with the rails on the Ranger, allowing leakage into the bed. I may investigate fully flat rail covers in the future.

I’ve use Extang tri folds for years on numerous trucks. I’ve never had a security issue, although a knife could allow forced entry.
My current issue is with the rails on the Ranger, allowing leakage into the bed. I may investigate fully flat rail covers in the future.

How much water leakage are you experiencing? I'm thinking about the same cover.

 

[Trust_But_Verify]

Installed the BAK Revolver. Amazon and RealTruck offered a $200 discount about a month ago......so I went with it. Installation was pretty easy (it's literally a 1 man job) and it fits reasonably well. Don't know how water tight it is, but that's not something that I'm terribly concerned about.

 

[Boosted6G]

Hard. Every single soft cover I've seen are all tattered, fade, and generally not good looking after a couple years.

Sponsored