BAK Revolver Installed Photos

[Trust_But_Verify]

I am talking with one of the sponsors to make a little taller rack that an X4s would fit under rolled up and need a few measurements. Maybe someone on this thread with an X4s on a Ranger can help.

What is the width of the Cover with the rubber edges ? What is the width of the cover and Rails? How tall is the X4s rolled up on the Ranger.?

Sponsored

 

[Designguy96]

Looks good! I've had mine for over a year and so far so good. The install was the hardest part. I wish they had better quality hardware. The quality seems to be lacking considering how much it costs.

I make and sell protective covers for those sharp raw edges at the end of the rails if you're interested.

BAK Revolver X4TS Protective End Cap - NEW V2! - Etsy

When I installed mine, I knew it was just a matter of time before I sliced my hand or leg on it.

Good luck with it!

 

[rocsteady]

Good to see this system works well for you, I have the MX4 and its junk, of course they recently updated it so maybe it got better. Realtruck ruined a lot of good company's products by cheaping out on everything but the cost to the consumer

I had one on a 2018 F150 and thought it was terrific? Had no issues. (From RealTruck by the way)

 

[alrashid2]

Hey guys, how hard was the install on the X4S? Wanting to buy one but a bit nervous I'll run into trouble. Local guy wants too much ($400) to install

 

[Trust_But_Verify]

Hey guys, how hard was the install on the X4S? Wanting to buy one but a bit nervous I'll run into trouble. Local guy wants too much ($400) to install

Installation is pretty simple if you've got basic handtools. I installed mine solo with no prior experience. There're plenty of install videos on youtube that'll give you an idea of what to expect. Here's one for an F-150:

 

[alrashid2]

Installation is pretty simple if you've got basic handtools. I installed mine solo with no prior experience. There're plenty of install videos on youtube that'll give you an idea of what to expect. Here's one for an F-150:

Thanks for sharing and for your experience!

 

[SoulMafia]

Installation is pretty simple if you've got basic handtools. I installed mine solo with no prior experience. There're plenty of install videos on youtube that'll give you an idea of what to expect. Here's one for an F-150:

Same for me!

 

[alrashid2]

Totally unrelated to this post, but I found out my father in law has this same cover and told me it is impossible to open during the winter. We are in PA where we get lots of snow, ice, and freezing temperatures. So sounds like this cover will be a no go for me...

Going to go with my backup of the Bakflip MX4 trifold instead!

Sponsored