What did you do to your Ranger Raptor Today?

[JrHDRanger]

Got my CAI from IndiCarbon today that I ordered several months ago. Had a few issues. The pipe that goes to the top charge pipe is at a weird angle to the Process West pipe. I got them connected but I’ll have to do some more adjusting this weekend so it looks better. Also, I should have put some washers under the gap where the air inlet is like they recommended in the video. Overtightened that and snapped it off (carbon fiber doesn’t bend). I’ll have to address that this weekend also. Got a zip tie there for now, it’s not pretty but it’s not going anywhere. Looks and sounds good except the things I need to straighten out when I have time. Just did a quick circle around the block for now so I don’t have any real impressions yet.

Sponsored

 

[rwolfcastle]

I relocated the trailer hitch wiring to the bumper using this kit: https://americanadventurelab.com/product/ford-ranger-trailer-plug-tuck-kit/

Worked super easy, had to grind down the inside of the adapter a little to get the trailer plug to click into place. Looks good and was an excuse to finally buy a cutoff wheel

Can you mount that kit vertically to match the standard Rangers? If so, would you still have to grind down the inside of the adapter to fit?

 

[SolarWinds]

Yesterday I installed a door deal between the front and rear doors on both sides. If there's a difference in sound level while driving, it's very minor. Probably not even a decible.

But, the material is dirt cheap, and the install takes just a few minutes per side, so why not?

 

[nate.co]

Can you mount that kit vertically to match the standard Rangers? If so, would you still have to grind down the inside of the adapter to fit?

I think it would fit vertically, but not 100% sure. You would still need to grind down the bracket to get the plugs to click into place. Also you will really want to grind off the existing bracket which is welded to the bottom of the bumper.

Sponsored