Foutz Rear Lower Arm Frame Guards

[tdroesch]

Hi All - picked up my RR last December after lurking here for a year and learning about the truck. All of your posts were super helpful in my decision to buy, and continue to help as I upgrade.

My question is regarding the Foutz rear lower arm frame guards. I banged my lower arm up slightly and lost the plastic cover while on 2N17X out to Arrowhead via 3N34 & 2N29Y, so now am looking for a little protection. I already have the buckle-up sensor guards and it looks like there will not be any interference with those. Anyone have these or heard of anything good/bad about them? And, if there are any other alternatives you can suggest, that would be greatly appreciated.

Cheers

Link to Foutz guards: https://www.foutzmotorsports.com/co...or-rear-lower-arm-frame-guard-with-hdpe-slide

Sponsored

 

[Arsenall11]

Ouch, spendy!

 

[pasali]

I’m running these and have punished them in Moab and other trails in southern Utah and Nevada. They slide right over obstacles and seem to be holding up well. The plastic slides do get scratched up, but that’s what they are for. Between these, their rear differential skid and a complete set of Rival skid plates, I don’t worry about anything when crawling trails in the 6-7 range on OnX.

 

[tdroesch]

good info thank you!

 

[CaptAngry]

The Foutz ones look like the best option for actual wheeling, but they are spendy. The Rival ones combine with the sensor guards but don't have that nice "ramp" for rock hits:

https://www.rival4x4usa.com/product...uminum-armor-set-2024-2025-ford-ranger-raptor

Still not cheap, but cheaper

 

[Stitsch1618]

Hi all just a note when having the Foutz differential protector on, the Rival Tank guard will interfere with it during installation - i had to grind some stuff off, and now i found out it will bend the back left corner of the tank guard down when in rough terrain. i will have to take some material off the tank guard back left (looking from the front) https://www.ranger6g.com/forum/thre...ctory-steel-fx4-skid-plates.16531/post-246724

 

[Stitsch1618]

Some more info on this: I had to cut a piece of the guard

Sponsored