OEM exhaust tips painted black?

[morahn]

so you dropped them down and then painted them?

Yes, I undid the end brackets (hope that makes sense) and placed a 2x4 or 2x6 piece of scrap wood (do not recall the length (4" or 6" max, it is whatever fit)) between the frame (or whatever was solid) as far up to the front of the vehicle to lower the exhaust for painting.

Do not force the exhaust to lower (not sure how to describe this but when the pipes are not attached at the end, there is some downward flex). I think I lowered the tips 6" maybe.

Also, I do not recall if there was another bracket that I undid further up the pipe, but I do not think so (take a look and if it looks easy to undo, go for it).

This is an underside photo with the wood block in the upper left hand side of the photo (Drivers side and I cannot tell exactly where the wood block was placed, kind of a useless photo):

I started at the tip of the exhaust and worked my way forward with the wood block, maneuvering around obstacles without forcing the exhaust pipe down too much, even switching wood blocks to get the best lowering of as much pipe as I could. Again, I painted a lot of the pipe that will never be seen

Sponsored

 

[superj]

I painted mine with normal matte black Walmart special paint. Its at the end of the exhaust system and never gets hot enough to need heat resistant paint. Its been in a good while, I just can't think when I did it (it's that long).

But I have the 2.3 godzilla so maybe that's why it lasts

 

[got3fords]

Before I installed them. Painted the outside and ends in Plastidip as I wanted a Matt black finish.

If you were so inclined for some reason, how hard would it be to remove them?

 

[celtic]

If you were so inclined for some reason, how hard would it be to remove them?

Take a razor blade or box cutter knife and cut lengthways, it just peels off.

 

[STEVE_K]

Those silicone covers are a pretty cool option.

 

[got3fords]

Those silicone covers are a pretty cool option.

Yeah, I think I'm going to order them after vacation.

 

[celtic]

Yeah, I think I'm going to order them after vacation.

Just make sure you fully coat the exhaust and inside of the tube with liquid detergent before installing otherwise it will stick halfway on.

 

[got3fords]

Just make sure you fully coat the exhaust and inside of the tube with liquid detergent before installing otherwise it will stick halfway on.

Duly noted.

 

[got3fords]

Duly noted.

What about spray silicone?

 

[celtic]

What about spray silicone?

Should work but I can only confirm that liquid detergent works as I did it and that it stays fixed after installation. That maybe a problem with silicone, too slippery?

 

[got3fords]

Should work but I can only confirm that liquid detergent works as I did it and that it stays fixed after installation. That maybe a problem with silicone, too slippery?

I appreciate your advice.

Sponsored