Before/After with 1" wheel spacers

[dpAtlanta]

The last time I installed wheel spacers was on a new 2003 Cobra. Ford tucked the wheels in too much for my taste.

I had zero issues. The Ranger Raptor looked like the wheels were tucked in too much as well.

I installed Titan wheel spacers, and I think it looks better now.

I also placed a flat edge against the front and rear tires and made a mark on the concrete to measure the track width.

The front now measures 81", and the rear measures 81 3/8".

I guess it is now into identification light territory width if I wanted to validate putting the three lights in the grill.

They look cool, but no current plans.

BEFORE:

AFTER:

Sponsored

 

[superj]

I used 1" spacers on my ranger and it did indeed look alot better, also

 

[skytrucker]

Looks good!

raises a question for me (I have no spacer experience,) is there any difference between spacers vs an equivalent wheel backspace/offset?
1” =about 25mm, would they be the same as a wheel with a 25mm offset (or 25mm different than the current wheel, atleast)

 

[danmoochie]

I love the look but still fear adding another failure point or causing possible suspension issues. My XLT FX4 would look way better with a set.

 

[BeachRaptor]

Looks good!

raises a question for me (I have no spacer experience,) is there any difference between spacers vs an equivalent wheel backspace/offset?
1” =about 25mm, would they be the same as a wheel with a 25mm offset (or 25mm different than the current wheel, atleast)

It’s inexpensive vs buying new wheels.

 

[NASSTY]

It’s inexpensive vs buying new wheels.

For me it wasn't an expense thing. I like the non-beadlock Raptor wheels more than any aftermarket wheels that I've seen yet so I added 1" Bora spacers. To get a slight bit more poke I went with 33x12.5x17 tires.

 

[BeachRaptor]

For me it wasn't an expense thing. I like the non-beadlock Raptor wheels more than any aftermarket wheels that I've seen yet so I added 1" Bora spacers. To get a slight bit more poke I went with 33x12.5x17 tires.

Not saying it’s always the reason. I used em on my wrangler for a couple of years. For me it was a cost thing. I saved for a while to buy new wheels so i could take the adapters off eventually. I never liked the stock wheels that came on it.

 

[BeachRaptor]

The last time I installed wheel spacers was on a new 2003 Cobra. Ford tucked the wheels in too much for my taste.

I had zero issues. The Ranger Raptor looked like the wheels were tucked in too much as well.

I installed Titan wheel spacers, and I think it looks better now.

I also placed a flat edge against the front and rear tires and made a mark on the concrete to measure the track width.

The front now measures 81", and the rear measures 81 3/8".

I guess it is now into indicator light territory width if I wanted to validate putting the three lights in the grill.

They look cool, but no current plans.

BEFORE:

AFTER:

The last time I installed wheel spacers was on a new 2003 Cobra. Ford tucked the wheels in too much for my taste.

I had zero issues. The Ranger Raptor looked like the wheels were tucked in too much as well.

I installed Titan wheel spacers, and I think it looks better now.

I also placed a flat edge against the front and rear tires and made a mark on the concrete to measure the track width.

The front now measures 81", and the rear measures 81 3/8".

I guess it is now into indicator light territory width if I wanted to validate putting the three lights in the grill.

They look cool, but no current plans.

BEFORE:

AFTER:

They definitely improve the stance. Looks good OP!

 

[Switzguy]

Looks good! Might consider doing this myself.

 

[skytrucker]

It’s inexpensive vs buying new wheels.

That’s what I thought, maybe a cheaper way to try out the wide-track setup…

 

[K_teven]

Very nice! I already added the ambers in my grill but I went with a four light set. Mine were under eBay Item # 305283610961. Wired them into the Aux Switch #1 easy as can be. Can you provide additional details on your Spacers? Thanks.

 

[dpAtlanta]

Very nice! I already added the ambers in my grill but I went with a four light set. Mine were under eBay Item # 305283610961. Wired them into the Aux Switch #1 easy as can be. Can you provide additional details on your Spacers? Thanks.

Here ya go:

https://www.titanwheelaccessories.c...6x139-7-93-1-hubcentric-12x1-5-studs-set-of-4

 

[goober71]

Looks great! Will these fit a 2024 XLT FX4? Also, it mentions you may need to grind the lug studs if they are longer than the thickness of the spacer. Did you have to do that?

G

 

[dpAtlanta]

Looks great! Will these fit a 2024 XLT FX4? Also, it mentions you may need to grind the lug studs if they are longer than the thickness of the spacer. Did you have to do that?

G

It says it will fit all 2019+ Rangers.
I did not have to grind anything.
If I did have to grind or modify them, I would not have purchased them.

 

[goober71]

It says it will fit all 2019+ Rangers.
I did not have to grind anything.
If I did have to grind or modify them, I would not have purchased them.

That's great! I'm definitely considering trying them out!

G

Sponsored