Super easy to remove, I can take out my Bakflip in two minutes all by myself. It's just a matter of loosening two knobs by hand. And yes, you can go with one, two or three panels open with total safety.
Very nice!Adding some photos here.
My wife's Ranger Raptor has a soft trifold as well. If that's what you mean by soft top? I have one on my F-150's and I like them. They do flap a little in the wind but thay work good, last a long time, and the snow slides off easy in Michigan.
Dang. Looks great!Are you sure this is a Bakflip? Looks like an Undercover Flex to me. My Bakflip MX4 has plastic end caps on the seals in all four corners.
My spray in liner is from Ford. At the front of the bed(bottom left and right) you can remove the plugs(?) and replace them with the ones that come with the liner(I got mine from Ford but I think yours is just about the same). Then run the hose out through them.
was there any issues when you removed the plugs? my bed is also sprayed on from the factory but i'm worried if try to take off the plugs it will mess up the surrounding bed spray.My spray in liner is from Ford. At the front of the bed(bottom left and right) you can remove the plugs(?) and replace them with the ones that come with the liner(I got mine from Ford but I think yours is just about the same). Then run the hose out through them.
Not if you are careful. The plugs are sprayed like the rest of the bed so I used a sharp knife to cut around the edge before I removed them. It didn't seem to harm the sprayed on bed liner. The spray on the plastic plug did come off easily So I took the edge part(see photo) and glued it to the new plugs that came with cover. The cut out to run the tube through was a bit big so I used a rubber grommet to give it a tight fit. I hope I explain that ok?
perfect, thanks for the tips.Not if you are careful. The plugs are sprayed like the rest of the bed so I used a sharp knife to cut around the edge before I removed them. It didn't seem to harm the sprayed on bed liner. The spray on the plastic plug did come off easily So I took the edge part(see photo) and glued it to the new plugs that came with cover. The cut out to run the tube through was a bit big so I used a rubber grommet to give it a tight fit. I hope I explain that ok?
Hope it works out.
Where did you order from? Yours looks perfect. How did you get it without Bakflip branding on it too?Are you sure this is a Bakflip? Looks like an Undercover Flex to me. My Bakflip MX4 has plastic end caps on the seals in all four corners.
I got it from tonneaucovered.com, great guys to deal with. It did indeed have a sticker that said ‘Backflip,’ but I removed it
How did you get the be caps by the cabin. I just bought MX4 from real truck and it doesn’t have the cap end it just runs offAre you sure this is a Bakflip? Looks like an Undercover Flex to me. My Bakflip MX4 has plastic end caps on the seals in all four corners.
