BAK Revolver Installed Photos

[Trust_But_Verify]

Was asked by a forum members for a few photos of the BAK Revolver tonneau that I had installed. In the event that others were researching/considering purchasing one for themselves, I thought I'd go ahead and share the photos with everyone. Hopefully they're helpful.

Sponsored

 

[alan0614]

Thank you sir.

 

[superj]

i really like the hard roll covers versus the soft roll and tri-fold hard covers. too bad they are so expensive.

 

[Depotgeorge]

I also have one it is pricey but is what I wanted and does fit very well a little tailgate gap. I did get the bak from ford when they had a 20% cupon no complaints

 

[LLCCPA]

I have the same cover and, honestly, have not been very happy with it. The latch mechanism has not held up. Plastic pieces have broken off.

 

[iBrad81]

Good to see this system works well for you, I have the MX4 and its junk, of course they recently updated it so maybe it got better. Realtruck ruined a lot of good company's products by cheaping out on everything but the cost to the consumer

 

[RealTruck]

The Revolver X4s looks sharp on your Ranger! It really has a clean look and fit once it's installed. Thanks for sharing the pics for everyone to see

 

[skinnyjimmy]

I have the exact some cover and LOVE IT.

 

[Blowndodge]

I have the same cover and, honestly, have not been very happy with it. The latch mechanism has not held up. Plastic pieces have broken off.

Until I read a lot of reviews of the same issues on the BAK I was going to buy it even though it's expensive. I ordered a $400 cover that is tri-fold and had good reviews. It's called the Tutel Hard Shell Folding Truck Bed Tonneau Cover. Installs in 15 minutes From Amazon.

 

[SoulMafia]

I have this one installed on my truck as well. Love the functionality but not sure the quality justifies the price…

 

[RealTruck]

I have this one installed on my truck as well. Love the functionality but not sure the quality justifies the price…

The functionality is what makes this cover stand out from others. Glad to hear you're loving it!

If you ever have any concerns about quality or un into issues, I'm here to help. PM me any time!

 

[nullderef]

I have the same cover and, honestly, have not been very happy with it. The latch mechanism has not held up. Plastic pieces have broken off.

I don't have a lot of confidence in the latch mechanism either.

 

[BrrRaptor]

I've had mine for over a year and it's a nice cover. Tad expensive.
Heads up, it does let some water in and also light amount of dust. I do park in a garage so it's not exposed to full sun and so far holding up.

 

[MoBob]

I am talking with one of the sponsors to make a little taller rack that an X4s would fit under rolled up and need a few measurements. Maybe someone on this thread with an X4s on a Ranger can help.

What is the width of the Cover with the rubber edges ? What is the width of the cover and Rails? How tall is the X4s rolled up on the Ranger.?

 

[nullderef]

What is the width of the Cover with the rubber edges ? What is the width of the cover and Rails? How tall is the X4s rolled up on the Ranger.?

I'm kinda intrigued to see this happen... but alas I do not have a straight edge long enough to accurately measure the width of the cover. I can say that the height of the rail itself is like 1/4" and the gasket effectively butts up against the cutout for the stake pocket cover at the tailgate.

As for how tall, mine was 7.5" rolled up (including the bumpers).

Sponsored