RC MUSTANG Azure Gray Raptor Build

[RCMUSTANG]

That one time I paid $3.49 for a set of 24 Gorilla wheel locks from Amazon.

Sponsored

 

[RCMUSTANG]

Fitcamx Dash cam. 80% fit. Front doesn't perfectly clip in but it's secure and the harness plugs right in. There is a gap at the rear where it should meet the headliner. Added a couple straps is foam to fill the gap. I'll sort out the rear camera later as the included one isn't water resistant and I want to mount it near the rear bumper area.

 

[RCMUSTANG]

Perfect spot for the rear dash cam. Tucks perfect even with the tailgate down. Cable was just long enough. Had to try and waterproof it but running silicone around the area where cam joins the main body as it was meant for inside mounting. Let's see if it works.

 

[RCMUSTANG]

Tempered glass screen protector.

 

[RCMUSTANG]

Stubby for clearance.

Radar detector hardwired.

 

[RCMUSTANG]

Was able to reuse rear crash bar plugs. Should keep the moisture out.

 

[RCMUSTANG]

Under hood light. Just need to order another switch. Can't find the one I took off the 2019.

 

[RCMUSTANG]

Ditch lights done. Connected to Aux switch 5. Have to say the driver mirror is so big I can't see much of what's lit on that side.

 

[RCMUSTANG]

Got the switch.

 

[RCMUSTANG]

Stock exhaust. Sound levels.
Startup 79 db
Quiet idle 59db
Quiet 3,000 RPM 71db
Normal idle 62db
Normal 3,000 RPM 76db
Sport idle 69db
Sport 3,000 RPM 81db
Baja idle 69db
Baja 3,000 RPM 84db
Videos are too big to upload directly. Linked to my IG

 

[RCMUSTANG]

Bad news for Raptor owners. Unless you want to cut sheet metal out bedside steps are not an option.

 

[RCMUSTANG]

One trombone loop added. Within an inch or two of being the same length on both driver and passenger exhaust into the muffler. Should have a more tuned sounding exhaust note now.

 

[RCMUSTANG]

Installed 12 volt and USB outlets. Bought the complete pigtail for the terminals pre-crimped.

 

[RCMUSTANG]

Train horn installed and wired. This is on the driver side bed cavity above the tailpipe.

 

[RCMUSTANG]

Compressor mounted in the passenger side bed cavity above the tailpipe. Air chuck outlet installed. Need to fabricate new mounting brackets for the tank and connect the hoses. Wired up.

Sponsored