What did you do to your Ranger Raptor Today?

[superj]

that sticker looks very nice

Sponsored

 

[PA RR]

Way better than the chrome

 

[embedded rock]

Relocating the trailer plug. Then removed the OEM bumper bracket.

 

[Dino Jockey]

Looks like it went well. Clean.

 

[OxygenMask]

Installing a bigger inverter. Routing the battery cables..

 

[Dino Jockey]

Bet that will spin up the voltage!!!

 

[jordantii]

Been a busy weekend. Finished the install of full underbody skids. All alone and on my back. Not bad for a grandfather. Lol

Then spent today installing @American Adventure LAb A-Pilar light mounts with Nacho Supreme 80’s. In the pic that’s just the back light. They are fully configurable with 3 low voltage trigger wires. At full bore all of the LED’s are on and pushing 80 watts. These things are the new standard. Bye bye BD, DD and Rigid.

 

[Watchdog62]

Wax on. Wax off.

 

[AssolMarandy]

Put the AirDesign cab spoiler on my ’24 RR a few weeks back and I’m happy with it. The CHMSL cutout lines up cleanly and the cargo light isn’t blocked at all; no extra wind noise up to highway speeds. Install was straightforward: clean with isopropyl, use the adhesion promoter, do a painter’s tape “hinge” to center it, press firmly, and don’t wash for 48–72 hours. On Oxford White the paint match is about a 9/10—only looks a hair warmer under certain lights—and I’ve noticed slightly less dust streaking on the rear glass after gravel runs. Only caution is if you run a rear roof crossbar or chase lights, check clearance first.

 

[JrHDRanger]

Added Ford Performance mud flaps and 1” wheel offsets from BuckleUp Off-road. I was regretting the mud flaps at first, stuck out too far past the tire. With the wheel offsets it looks really good now.

 

[Dino Jockey]

Received, assembled, and installed the 2 AAL bed rails. Like running a toolbox so I only needed 2. Underneath is a diy bi-fold tonneau. The 10” rails still allow opening of the cover enough to facilitate reaching items in bed. Thanks to @American Adventure LAb for the great product and customer service!

 

[sign1941]

Put the AirDesign cab spoiler on my ’24 RR a few weeks back and I’m happy with it. The CHMSL cutout lines up cleanly and the cargo light isn’t blocked at all; no extra wind noise up to highway speeds. Install was straightforward: clean with isopropyl, use the adhesion promoter, do a painter’s tape “hinge” to center it, press firmly, and don’t wash for 48–72 hours. On Oxford White the paint match is about a 9/10—only looks a hair warmer under certain lights—and I’ve noticed slightly less dust streaking on the rear glass after gravel runs. Only caution is if you run a rear roof crossbar or chase lights, check clearance first.

have any Pics?

 

[forestclouds]

Received, assembled, and installed the 2 AAL bed rails. Like running a toolbox so I only needed 2. Underneath is a diy bi-fold tonneau. The 10” rails still allow opening of the cover enough to facilitate reaching items in bed. Thanks to @American Adventure LAb for the great product and customer service!

That looks great. Good job!

And I agree, @American Adventure LAb has great products and customer service.

 

[embedded rock]

Bolted up a transmission skid plate and changed the oil.

 

[landiscarrier]

Installed some Buckle Up Off Road 1” wheel spacers (front and back)My truck won’t see any major off roading so I’m not worried about the spacers. I like the slightly wider stance.

Sponsored