Door Power Window Recall on 2024 Rangers (per NHTSA)

[BriSco]

Components: power windows

Affected vehicles: select 2024 Ford Ranger pickups produced at the Michigan Assembly plant that are equipped with the recalled Driver Door Module (DDM) and Passenger Door Module (PDM) introduced into production on December 9th, 2022 and taken out of production on July 15th, 2024.

Number of vehicles affected: 70,483

Owners should: wait for communications from Ford, which will begin on September 23rd, 2024. The Ford reference number for this recall is 24C24.

The fix: dealers will update the Driver Door Module and the Passenger Door Module software, free of charge.

Contacts:

• Ford Customer Service: 1-866-436-7332
• FoMoCo Recall Number: 24C24
• NHTSA Toll-Free: 1-888-327-4236
• NHTSA (TTY): 1-800-424-9153
• NHTSA Website: www.nhtsa.gov

Sponsored

 

[Ag3ntC00p3r]

Was just about to report an issue I have been having with passenger side window. Every so often, when I would try to close the passenger window from full open it would start moving up but then roll back down on its own.

 

[CherryCoke]

Mine have high ping . A little delay to lower and raise the front windows.

 

[Elgin_Ranger]

Can I now log in to my Ford account and see the recall?

 

[GFran]

Was just about to report an issue I have been having with passenger side window. Every so often, when I would try to close the passenger window from full open it would start moving up but then roll back down on its own.

Yep, i have a 2024 F150 XLT Rental with only 4100 miles and the passenger side window did me the same thing.

 

[Ag3ntC00p3r]

Mine have high ping . A little delay to lower and raise the front windows.

It's probably because the signal from the switch goes to the infotainment screen to be sent out as a Cloud command to be routed to the 3G modules on the window motors.

 

[FossIsleBC]

Components: power windows

Affected vehicles: select 2024 Ford Ranger pickups produced at the Michigan Assembly plant that are equipped with the recalled Driver Door Module (DDM) and Passenger Door Module (PDM) introduced into production on December 9th, 2022 and taken out of production on July 15th, 2024.

Number of vehicles affected: 70,483

Owners should: wait for communications from Ford, which will begin on September 23rd, 2024. The Ford reference number for this recall is 24C24.

The fix: dealers will update the Driver Door Module and the Passenger Door Module software, free of charge.

Contacts:

• Ford Customer Service: 1-866-436-7332
• FoMoCo Recall Number: 24C24
• NHTSA Toll-Free: 1-888-327-4236
• NHTSA (TTY): 1-800-424-9153
• NHTSA Website: www.nhtsa.gov

Thanks for posting this @BriSco

Maybe @Ford Motor Company can ship the j braces they knew were necessary and should have been installed on the assembly line to all the dealers so they can install them for us while we’re in getting our windows fixed

 

[Dubfound]

Dang! Thanks for posting this!!! My RR was in for an oil change and I told them I was getting wind noise in my driver window.

 

[jrRaptor]

Can I now log in to my Ford account and see the recall?

Mine hasn't shown up yet.

 

[Zangor]

I noticed this day 1 of owning the truck but didn’t think it was a big deal.

for those that haven’t experienced it yet, use your key fob to roll up and roll down all 4 windows as the same time.

the front windows will try to close, but then will go back to a partly open position.

if you didn’t know- on your key fob while you are outside of the vehicle- click unlock once, then click again and hold a few seconds until they open. Stay holding until the operation is complete.

Do this on the lock button to close

 

[OddEntity]

Mind blown...

 

[Jason B]

I noticed this day 1 of owning the truck but didn’t think it was a big deal.

for those that haven’t experienced it yet, use your key fob to roll up and roll down all 4 windows as the same time.

the front windows will try to close, but then will go back to a partly open position.

if you didn’t know- on your key fob while you are outside of the vehicle- click unlock once, then click again and hold a few seconds until they open. Stay holding until the operation is complete.

Do this on the lock button to close

Good to know. I didn't know that feature was possible on the 6G.

My guess is the window up is too sensitive to obstructions. It may think someone's arm or head is out the window.

 

[FossIsleBC]

Good to know. I didn't know that feature was possible on the 6G.

My guess is the window up is too sensitive to obstructions. It may think someone's arm or head is out the window.

apparently it’s the opposite - not sensitive enough and doesn’t detect fingers etc and closes on them. Per Ford Authority, recall 24C24:

https://fordauthority.com/2024/08/2024-ford-ranger-recalled-over-window-pinching-issue/

 

[pablo94sc]

I'm still trying to figure out how global open/close works without 1-touch rear windows. I thought you couldn't have one without the other?

 

[Critical Habitat]

Probably not the last recall.

Sponsored