• Welcome to Ranger6G.com everyone!

    If you're joining us from Ranger5G, then you may already have an account here! As long as you were registered on Ranger5G as of March 27, 2020 or earlier, then you can simply login here with the same username and password.

Sponsored

egecikrikci

Member
First Name
Ege
Joined
Jun 29, 2025
Threads
2
Messages
6
Reaction score
2
Location
Turkey
Vehicle(s)
Ford Ranger Wildtrak 25'
Just picked up a 2025 2.0 Wildtrak w/ 360 cam + radar pack. It should have Intelligent ACC (stop & go), but turns out — nope. Ironically, base Wildtrak in TR has IACC, but the higher 360 pack doesn’t. Guessing Ford limited it due to compute constraints?

Anyway, my truck has full radar, EPB, electric brake controller, etc. ACC works but no lane centering, no stop&go cuts off below 15kmh -and lane assist just lane bounce. Want to enable IACC + Lane Center + Traffic Jam Assist via FORScan if possible. Anyone pulled this off on a 2023+ Ranger?
Sponsored

 

Jeffola

Well-Known Member
First Name
Jeff
Joined
May 30, 2024
Threads
15
Messages
121
Reaction score
153
Location
Southeast Florida
Vehicle(s)
2024 Ranger Raptor, 2019 Shelby GT350
Occupation
Business Development
Note that on this sheet, if you are looking at any of the settings on the "TBD" tab, the cells are shaded yellow which means they have not been tested yet by anyone here and thus may not be accurate. On the "Confirmed" tab they are shaded green and at least one person here has confirmed it works on their truck.

Having said that, note that the this was still TBD when you tried it, and that version said to set the value in the APIM to 8, which is not accurate. I finally got a chance to check this out (sadly I did this because I had to tow my boat to the shop for a blown cylinder), and can confirm it works on my NA Lariat with basic Tow package. But the value should not be set to 8, instead you should "add 8" to whatever is there already on 7D01-02-03 (in my case I had a 5 there, so had to change it to D). But the recommended setting for the APIM part is to use the "non Asbuilt" and instead of messing with bits and bytes - just use the drop down to enable "Turn Signal Views".

** Make sure you also make the change to the IPMA module, which does not have a non as-built menu option, so that one you can just add 3 to enable both cameras (in my case it was 0 so I changed it to 3)

Here's what it looks like now that I have confirmed it works. Note that Ford may still disable this if there is a limitation in your country.

1728065141003-ig.jpg
Been searching this thread (Like we all do) and dowering if the mirror mode works without a trailer? Of course I am asking for a friend.
 

dudufritzen

New Member
First Name
Eduardo
Joined
Jul 4, 2025
Threads
0
Messages
1
Reaction score
0
Location
Brazil
Vehicle(s)
Ranger Limited+ 2025
I went to enable Trail turn assist and my abs section doesn't match what the spreadsheet has.... The 760-03-1 part... I have a 2025 US spec

PXL_20250629_142814961.jpg
I have a 2026 Argentina ranger and I'm experiencing the same problem, we have 3 ABS blocks with completely different coding than any spreadsheet. I tried adding 8 to Hex, but Forscan doesn't record and displays the message "Service procedure has been interrupted". Does anyone have a solution?
 

Cabose-1

Member
First Name
Eli
Joined
Feb 23, 2025
Threads
0
Messages
13
Reaction score
18
Location
South Texas
Vehicle(s)
2024 xlt 4x2, advance tow elocker
Occupation
Student
It has been a while since I posted here. Had a problem with my scanner and had to buy a new one.

Now i'm trying to activate the rear camera at speed. Does anyone with just the rear camera was able to do it? I have a feeling it only works with the 360 camera system.

I was able to enable this icon at APIM module, but when I click it nothing happens.

1749425553739-ex.jpg


I'm also wondering if there's a way to activate Alexa. At APIM module I enabled it but can't find it anywhere. Any ideas?
I was able to turn rear camera on at speed. That is the only camera i have. Also made the "full view not available go away. Its in the spread sheet here on the asbuilt sheet. Works like a charm.

2024, 2.3l, xlt, 4x2, advance tow, elocker.
 

Matiasjf

New Member
First Name
Matias
Joined
Jul 4, 2025
Threads
0
Messages
1
Reaction score
0
Location
Argentina
Vehicle(s)
ranger 2024 black
Occupation
abogado
Hello, could someone tell me the steps to activate and operate the automatic air conditioning with Forscan?
 

Sponsored
OP
OP
craigc

craigc

Well-Known Member
First Name
Craig
Joined
Aug 28, 2023
Threads
10
Messages
303
Reaction score
231
Location
Allen, TX
Vehicle(s)
2024 Ford Ranger Lariat FX4
Been searching this thread (Like we all do) and dowering if the mirror mode works without a trailer? Of course I am asking for a friend.
Not sure I exactly follow your question, but if what you are asking is if the camera turns on on when left or right blinker is on but with no trailer, it does not. it only works for me when towing a trailer.
 

dsmclark

Member
First Name
Sam
Joined
May 16, 2024
Threads
0
Messages
21
Reaction score
9
Location
Dorset
Vehicle(s)
Ford Ranger Raptor
Has anyone had any luck making changes on the PCM module?

I’m pretty sure the second digit in the field circled should be 4 and when I put that in it gets to about 80% then fails. Not sure what the 6C means either. Anyone else here with a ranger raptor that can post a screen shot of what theirs shows. This is to try and get the active shutters on the intercooler to open. Thanks

Ford Ranger FORScan NA Ranger 6th Gen (2024+) Crowdsourced Spreadsheet IMG_1273
Sponsored

 
 







Top