How do you make numerical temperature readings visible? Like 120F and 69FIām not entirely sure what you want.
Hereās how mine works currently with the code ive shared.
With either front passenger unbuckled, the dash seat icon lights up:
However, i just found out a rear seat passenger will not trigger the unbuckled warning.
I switched the my view over to seatbelts, and it does not know thereās a rear seat passenger.
However, when the rear passenger buckles up, it does show that:
Yes, the front seats light up red on the seatbelt screen with no passenger. I didnāt return the code to stock to test, but Iām not sure my truck detects rear passengers at all.
I donāt have kids, so not a concern for me. Best of luck figuring out a solution that works for you.
Nope, you will be the testerDoes anyone know if this will actually disable the start stop feature on the Ranger. Found this in the PSCM module:
this is how I turned off the start stop on my Raptor 2023Does anyone know if this will actually disable the start stop feature on the Ranger. Found this in the PSCM module:
| Disable Auto Start-Stop | BdyCM | 726-48-02 | x*xx-xxxx-xxxx | *=0 |
| BMS Configuration | BdyCM | NON-ASBUILT | BMS Configuration | PWM |
| Auto Stop Start | IPC | NON-ASBUILT | Auto Stop Start | Disable |
| Battery Target State of Charge, % | BdyCM | NON-ASBUILT | Battery Target State of Charge, % | 100% |
Someone want to try it NA Ranger? I might tried if I have time to play around with my laptop.
There have been several threads about FORScan, but would like to consolidate into one place like was done for the 5G Ranger.
The below document will be updated as people give confirmation as to what works and what does not. I am hoping to find GUI changes as Asbuilt changes together if possible, like you will see on the Confirmed tab for the Chimes and Bambi mode
Web version: FORScan NA Ranger 6G
Actual Gsheet: FORScan NA Ranger 6G - Gsheet
The 3 most useful tabs:
- Features Confirmed - these are options that are proven to work on the Ranger
- Features TBD - these were collected from F150, Ranger5G, and Bronco and need to be confirmed
- FORScan GUI - this is a dump of all the options for all NON-ASBUILT module pages in FORScan while connected to a 6G Ranger
IF YOU CAN CONFIRM a configuration change works, if you could post to this thread with this information:
- Feature name from the Feature Tab
- What value you changed from -> to (asbuilt only, or GUI)
- Ranger trim level tested on
- Any side effects or gotchas when making the change
- Any other details of what the feature actually does (in layman terms)
Please PM me if you would like to be an editor for this sheet or request access from within the Gsheet.
** NOTE ** The sheet may take some time for changes to get entered after there are posts with confirmations. So be patient please
I have wondered the same thing... I am keen to try it next time I head off-road as the way the TPMS works thus far when operating at reduced tyre pressures is nothing short of infuriating. Resetting your pressures results in no low pressure warnings for about 5 seconds before the stupid low pressure warning pops up again. As it is, TPMS is useless when off-roading with lowered pressures.
I think you can adjust TPMS pressures. "TPMS Placard value" in IPC non-asbuilt menu if I remember correctly...
Mine definitely has off road tpms as well as normal tpms, I will try it this week I can only assume it applies itself when you select an off road mode, will let you know how it goes.
I gave instructions in a previous post. It works for me on a Raptor 2023
